Pull request

Hello Wolfgang,

The following changes since commit 61ddce07f8b96c5df7d00466b4da9edaecb0eff1:

sandbox: Use the new run_command() (2012-04-23 22:53:54 +0200)

are available in the git repository at:
git://git.denx.de/u-boot-i2c.git master

Armando Visconti (1):
i2c:designware Turn off the ctrl when setting the speed

Nobuhiro Iwamatsu (1):
sh: i2c: Add support I2C controller of SH7734

Vipin KUMAR (1):
i2c: Add support for designware i2c controller

 drivers/i2c/Makefile                               |    3 +-
 drivers/i2c/{spr_i2c.c => designware_i2c.c}        |   15 +-
 .../spr_i2c.h => drivers/i2c/designware_i2c.h      |    6 +-
 drivers/i2c/sh_sh7734_i2c.c                        |  387 ++++++++++++++++++++
 include/configs/spear-common.h                     |    2 +-
 5 files changed, 406 insertions(+), 7 deletions(-)
 rename drivers/i2c/{spr_i2c.c => designware_i2c.c} (95%)
 rename arch/arm/include/asm/arch-spear/spr_i2c.h => drivers/i2c/designware_i2c.h (98%)
 create mode 100644 drivers/i2c/sh_sh7734_i2c.c

"MAKEALL arm" shows:

[hs at pollux u-boot-i2c]$ eldk-switch -r 5.1 armv5te Setup for armv5te (using ELDK 5.1)
[hs at pollux u-boot-i2c]$ ./MAKEALL arm
[...]
--------------------- SUMMARY ---------------------------- Boards compiled: 277
----------------------------------------------------------
[hs at pollux u-boot-i2c]$

bye,
Heiko

DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany

Dear Heiko Schocher,

Applied, thanks.

Best regards,

Wolfgang Denk

DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
You can do this in a number of ways.     IBM chose to do all of them.
Why do you find that funny?        -- D. Taylor, Computer Science 350