Skip to contentSkip to conversation

UAC2 defaults to max sampling rate

DISCUSSION adelias 2 participants 2 messages May 23, 2012

lore
Share & tools
lore

adelias

author
#0 lore raw

Hi,

I'm running ALSA 1.0.23 and kernel 2.6.37 on ARM. The UAC2 audio device is the XMOS reference board.

This is what I'm observing. As soon as the XMOS board is plugged in to the USB port, the display on my DAC indicates that is has locked at 192kHz which is the maximum sampling rate supported by the XMOS.

Is this the expected behavior or can I specify the defualt sampling rate at start up?

Thanks

#1 lore raw
Quoted 6 lines · adelias

I'm running ALSA 1.0.23 and kernel 2.6.37 on ARM. The UAC2 audio device is the XMOS reference board.

This is what I'm observing. As soon as the XMOS board is plugged in to the USB port, the display on my DAC indicates that is has locked at 192kHz which is the maximum sampling rate supported by the XMOS.

This is an as-yet unfixed bug in the driver.
(The usb_set_interface call in snd_usb_add_endpoint is completely superfluous.)

Regards,
Clemens