Skip to contentSkip to conversation

Almost no traffic in br0 / tap0 combination

Bridge Bernhard Walle 1 participant 1 message Jun 17, 2012 Ethernet bridge

lore
Share & tools
lore
#0 lore raw

Hello,

probably the question is stupid, but I just don't get it.

I have a Linux host with a bridge that contain my normal eth interface and a tap device. The br0 interface has the IP address, tap0 and eth0 are up and don't have any IP.

The tap0 interface is opened and read()s the frames coming in. On a second console, tcpdump is monitoring the traffic. No traffic is actually written to the tap0 interface.

# brctl show
bridge name	bridge id		STP enabled	interfaces
br0		8000.a24ecad3959c	no		eth0
							tap0
No iptables. I configured even hub-like behaviour:
# brctl setageingtime br0 0
# brctl setfd br0 0

Now my question: Why don't I see any traffic apart from broadcasts? Shouldn't I see any traffic that is incoming? Because both eth0 and tap0 are in promisc mode?

Thanks for the advise!

Regards,
Bernhard