Skip to contentSkip to conversation

Dual Xeon Time skips with 2.6

DISCUSSION Robert Hancock 3 participants 3 messages Oct 10, 2005 – Oct 11, 2005 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 15 lines · Cornelius Thiele

Hello,

we have a dual xeon 3,0ghz system with hyperthreading running here with kernel 2.6.13 / 2.6.12 and are experiencing time skips. Meaning, when you enter 'date' in the shell the result will be different depending on which cpu the command is scheduled. The longer the system is up the greater the difference. The increase is approximately 5 minutes per day; as you can probably imagine this adds up to quite a lot over weeks and screws up our logging and any other program that needs timing or writes timestamp to disk somewhere.

$> / # dmesg | grep time
time.c: Using 3.579545 MHz PM timer.
time.c: Detected 3000.236 MHz processor.
Using local APIC timer interrupts.
Detected 12.500 MHz APIC timer.
time.c: Using PIT/TSC based timekeeping.

[ ... w/o bogomips and pci timing... ]

The CPUs seem to be put in sync only at system startup:

Quoted 8 lines

dmesg | grep TSC
CPU 1: Syncing TSC to CPU 0.
CPU 1: synchronized TSC with CPU 0 (last diff 142 cycles, maxerr 1267 cycles) [... for CPU1-4 ...]

but they drift apart quite heavily after that.

The server runs on a Tyan Mainboard, I'd be happy to provide any more infos if needed or try out some things, because we really need to have a server with only _one_ system time :)

You can probably avoid this problem by using "notsc" on the kernel command line. It would seem that somehow the TSC drift is too small for the kernel to notice on boot, but causes problems anyway..

Signature · 3 lines
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from [email protected]
Home Page: http://www.roberthancock.com/
#2 lore raw
Quoted 2 lines · Robert Hancock

You can probably avoid this problem by using "notsc" on the kernel
command line. It would seem that somehow the TSC drift is too small for the kernel to notice on boot, but causes problems anyway..

Thanks very much, that fixed it.

Greetings,
Cornelius Thiele

#3 lore raw
In reply to Robert Hancock
Quoted 2 lines · Robert Hancock

You can probably avoid this problem by using "notsc" on the kernel command line. It would seem that somehow the TSC drift is too small for the kernel to notice on boot, but causes problems anyway..

This sounds familiar, although much larger than what I see, is it possible for an Intel dual core CPU to do this as well? I sometimes see very unintuitive timestamps on network stuff.

Signature · 3 lines
   -bill davidsen ([email protected])
"The secret to procrastination is to put things off until the
 last possible moment - but no longer"  -me