Skip to contentSkip to conversation

LVM2 striping or md raid0

linux-lvm Kelly Byrd 1 participant 1 message Sep 25, 2007 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

Kelly Byrd

author
#1 lore raw
Quoted 28 lines · Kelly Byrd
Quoted 24 lines · Chris Cox
Quoted 22 lines · Kelly Byrd
Quoted 7 lines · Kelly Byrd

Two questions really:

I'm going to use lvm to partition up 4 equal size partitions. I can either use the md driver to RAID0 them the make /dev/md0 my PV, or just use the 4 partitions as PVs and stripe across them.

Quoted 9 lines

How does lvm2 striping compare with md's RAID0 as far as speed? I don't quite get how it stripes on chunk sizes smaller than a PE, but a 4MB stripe size seems crazy.

Finally, what's the tuning advice for LVM2 striping? I usually create my RAID0 or RAID5 with 128k chunk sizes, is it similar for LVM2 striping?

anyone?

Quoted 9 lines
Quoted 8 lines

This is merely my own opinion, but md was designed to be THE software raid mechanism. So, my preference would be to establish a RAID md device and make that into a PV.

Of course, I don't believe in non-RAID (i.e. RAID0) anyhow. Maybe someone else will chime in on this one.

I had the same thought, but there's also this instinct that 'one less layer between my files and this physical disk is better'. I'm really hoping someone will say something like:
'LVM2 striping uses the same code as md raid0' or some other silly thing.