DMA blues... (Raid5 + Promise ATA/100)
I have a software raid setup using the latest kernel, but the system keeps crashing.
Each drive is connected to the respective ide port via ATA100 capable cables. Each drive is a master..no slaves. The configuration is that /dev/hdc is a hot spare and /dev/hd[e,g,i,k,m,o,q,s] are all setup as raid 5. These are all 75GB drives and are recognized as such.
I have searched the linux-kernel archives and saw many posts addressing the problems that I was experiencing, namely the freezing caused by the code in the body of delay_50ms() in drivers/ide/ide.c. This was fixed in the current patch and as discussed earlier on the linux-kernel mailing list by using mdelay(50). This fixed the problems to some extent, the system seemed very reliable and I did not get a single "DriveStatusError BadCRC" or a "DriveReady SeekComplete Index Error" for a while. But after I had copied a large amount of data to the raid, about 17GB, the system crashed completely and could only be recovered by a cold reboot. Before using the latest patches, the system would usually crash after about 4-6GB of data had been moved. Here are the log entries...
Feb 12 06:41:12 bertha kernel: hdo: dma_intr: status=0x53 { DriveReady SeekComplete Index Error }
Feb 12 06:41:12 bertha kernel: hdo: dma_intr: error=0x84 { DriveStatusError BadCRC }
Feb 12 06:45:42 bertha kernel: hdo: timeout waiting for DMA
Feb 12 06:45:42 bertha kernel: hdo: ide_dma_timeout: Lets do it again!stat = 0x50, dma_stat = 0x20
Feb 12 06:45:42 bertha kernel: hdo: irq timeout: status=0x50 { DriveReady SeekComplete }
Feb 12 06:45:42 bertha kernel: hdo: ide_set_handler: handler not null; old=c01d0710, new=c01dac70
Feb 12 06:45:42 bertha kernel: bug: kernel timer added twice at c01d0585.
Feb 12 09:13:15 bertha syslogd 1.3-3: restart.Let me know If I should post any additional information that might help in troubleshooting. Is this a possible issue with the kernel code or is this a problem with hardware? Any help is appreciated...
- Jasmeet Sidhu
Some other info that might help:
[root@bertha /root]# uname -a
Linux bertha 2.4.1-ac9 #1 Mon Feb 12 02:43:08 PST 2001 i686 unknown
Patches Applied to Kernel 2.4.1:
1) ide.2.4.1-p8.all.01172001.patch
2) patch-2.4.1-ac9
Asus A7V VIA KT133 and Onboard Promise ATA100 Controller (PDC20267) 1GHz AMD Thunderbird Athalon Processor
Four Promise PCI ATA100 Controllers (PDC20267)
Netgear GA620 Gigabit Ethernet Card
Boot Drive (Root + Swap)
hda: IBM-DTLA-307020, ATA DISK drive
Raid 5 Drives:
hdc: IBM-DTLA-307075, ATA DISK drive *SPARE*
hde: IBM-DTLA-307075, ATA DISK drive
hdg: IBM-DTLA-307075, ATA DISK drive
hdi: IBM-DTLA-307075, ATA DISK drive
hdk: IBM-DTLA-307075, ATA DISK drive
hdm: IBM-DTLA-307075, ATA DISK drive
hdo: IBM-DTLA-307075, ATA DISK drive
hdq: IBM-DTLA-307075, ATA DISK drive
hds: IBM-DTLA-307075, ATA DISK drive
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://vger.kernel.org/lkml/