Skip to contentSkip to conversation

Burst Rate?

LARTC Scott Baker 1 participant 1 message Jan 29, 2004

lore
Share & tools
lore
#0 lore raw

If I'm using the following to very simply police my incoming bandwidth:

ingress {
$p = bucket(rate 7Mbps, burst 1000kB, mpu 200B); class (1) if (conform $p && count $p) || drop;
}

How should i be calculate the burst rate? Cisco has their own special algorithm for calculating the correct burst rate, is there a similar method I should be using to calculate burst on a linux box? Also are there any improvement in the 2.6.x kernel with regards to traffic shaping?

Scott

Scott Baker - Network Engineer - RHCE
bakers @ web-ster . com - 503.266.8253

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/