MDADM after QNAP Support disaster QNAP 859 Pro

Hello
a few days I received a NAS with 8 Slots. The original config consistet of 8* 2TB HDs as a RAID6 mdadm softraid system. After a normal reboot the array was no longer found, so QNAP was contacted. The support told the keyuser todo this:

mdadm -D /dev/md0 (zeigt das gesamte RAID auf)
to assemble the HDs you have to:
mdadm -A /dev/md0 /dev/sda3.... (take care here, depending on the HDs they get a value like /dev/sdb3 dev/sdc3 ...) - with 8 HDs:
mdadm -A /dev/md0 /dev/sda3 /sdb3 /dev/sdc3 /dev/sdd3 /dev/sde3 /dev/sdf3 /dev/sdg3 /dev/sdh3 (be careful with the order!) If you get an error message about the assemble, you have to stop md0
mdadm -S /dev/md0 (stopping md0)
umount /dev/md0 (unmount of md0)

After serveral failed tries it endet in have a RAID 1 Konfig on sda and sdb but not seeing anything else of the config before (funnily only a 500MB partition (as /dev/md9 sounds as a lot of tries). As I'm not using mdadm in my workplace anywhere:

How can I delete the RAID1 (pretty simple I know) and reconstruct the R6 Array without damaging the config further (and therefore the datas). The R6 should be about 11TiB usable size.
Is there a init build with searching for the old conifg? As R6 it should even be readable without sda or sdb if this should be needed. I manly use HW RAID Controller where a few (ICP, Infortrend, Areca) which allows a reassembly by just declaring the disks as member to mdx and assemble then again; I hope mdadm could offer something similar

Cheers
Sam

The advice you were given doesn't seem very helpful.

Please run

mdadm --examine /dev/sd*

collect the output, and post it.

NeilBrown