qethconf does not work correctly over bonding devices
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 7 lines · Xose Vazquez Perez
Quoted 6 lines
hi,
# qethconf vipa add "IP" bond0 : up and running.# qethconf vipa del "IP" bond0 : it does not work.
Quoted 7 lines
Quoted 5 lines
# qethconf list_all : this shows nothing.tested on SLES 10-SP4, LPAR z10 2097 E64
-thanks-
done with s390-tools-1.17.0
What do you want to configure here? Mixing qethconf with a bonding interface does not make sense. qethconf is a configuration tool for OSA-Express cards in Layer3 mode; thus it should be used for qeth interfaces only, not for bonding interfaces. Bonding on the other side requires Layer2 slaves; thus there is no need to make use of qethconf for OSA bonding slaves.
Kind regards, Ursula Braun, IBM Germany