Skip to contentSkip to conversation

Question: how can I get the real PCI address of a BAR?

DISCUSSION Cédric Cano 2 participants 3 messages Dec 28, 2012 – Jan 3, 2013 PCI

lore
Share & tools
lore
#0 lore raw

Hi,

I'm writing a driver for a DMA engine on the PCI bus. My architecture is a 36-bit PowerPC (MPC85xx).

In my DMA driver, I want to configure the DMA to transfer data to/from a PCI device.
I get the PCI address of the device BAR with the command pci_resource_start.
This address is 36-bit but the PCI BAR of the device is 32-bit: I can't use the 36-bit address to run the DMA.

In kernel documentations, it's advised not to directly read the BAR.

Is there a function which provides the real PCI address i.e. the one stored in the BAR?

Thanks.

C. Cano

maintainer
#1 lore raw
Quoted 8 lines · Cédric Cano

Hi,

I'm writing a driver for a DMA engine on the PCI bus. My architecture is a 36-bit PowerPC (MPC85xx).

In my DMA driver, I want to configure the DMA to transfer data to/from a PCI device.
I get the PCI address of the device BAR with the command pci_resource_start.

pci_resource_start() doesn't give you a PCI bus address; it gives you a CPU physical address. You ioremap() that address if you want a CPU to access the BAR MMIO space.

Quoted 7 lines

This address is 36-bit but the PCI BAR of the device is 32-bit: I can't use the 36-bit address to run the DMA.

In kernel documentations, it's advised not to directly read the BAR.

Is there a function which provides the real PCI address i.e. the one stored in the BAR?

You can use pcibios_resource_to_bus() to convert the CPU physical address from the pci_dev.resource[] back to a PCI bus address. sym_iomap_device() does something similar to what you're asking about.

Bjorn

#2 lore raw

Hi,

pcibios_resource_to_bus() does what I need.

Thanks.

Quoted 26 lines · Bjorn Helgaas
Quoted 8 lines · Cédric Cano

Hi,

I'm writing a driver for a DMA engine on the PCI bus. My architecture is a 36-bit PowerPC (MPC85xx).

In my DMA driver, I want to configure the DMA to transfer data to/from a PCI device.
I get the PCI address of the device BAR with the command pci_resource_start.

pci_resource_start() doesn't give you a PCI bus address; it gives you a CPU physical address. You ioremap() that address if you want a CPU to access the BAR MMIO space.

Quoted 7 lines

This address is 36-bit but the PCI BAR of the device is 32-bit: I can't use the 36-bit address to run the DMA.

In kernel documentations, it's advised not to directly read the BAR.

Is there a function which provides the real PCI address i.e. the one stored in the BAR?

You can use pcibios_resource_to_bus() to convert the CPU physical address from the pci_dev.resource[] back to a PCI bus address. sym_iomap_device() does something similar to what you're asking about.

Bjorn