Hob interface

I pulled day before yesturday and I am trying to start with a base image and add stuff to make a custom build. But I cannot save, there is no template button.
Does it now edit the files in the current conf dir?
I liked the concept of being able to start with a know image, save it out as a named template then edit, save(before I spend hours building) then build and test.

Hi Jeff,

Yes, it is one of the change that we made in 1.4 for unify the config changes between hob and underline bitbake, but we went a little bit too far by removing the template capability. Restore template is one of the scheduled bug fixes for 1.5 and probably we'll push it into 1.4.1 release.

Thanks,
Jessica

-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Jeff Shanab
Sent: Monday, May 06, 2013 7:16 PM
To: [email protected]
Subject: [OE-core] Hob interface

I pulled day before yesturday and I am trying to start with a base image and add stuff to make a custom build. But I cannot save, there is no template button. Does it now edit the files in the current conf dir?
I liked the concept of being able to start with a know image, save it out as a named template then edit, save(before I spend hours building) then build and test.

_______________________________________________
Openembedded-core mailing list
[email protected]
http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/openembedded-core