mtd_dataflash cause udev hang

Hi,

I am working on the at91sam9x5 boards. I added the DataFLash partitions on board-sam9x5.c file.

It hangs while booting up the board after Starting udev message and after that getting the following messages.

Starting udev

udevd (672): /proc/672/oom_adj is deprecated, please use

/proc/672/oom_score_adj

instead.

then these traces come out.

udevd[672]: worker [688] unexpectedly returned with status 0x0100

udevd[672]: worker [688] failed while handling

'/devices/virtual/block/loop0'

udevd[672]: worker [691] unexpectedly returned with status 0x0100

udevd[672]: worker [691] failed while handling

'/devices/virtual/block/loop1'

udevd[672]: worker [692] unexpectedly returned with status 0x0100

1. Enable and ported the DMA Engine code from 2.6.39 kernel to

     3.2.6 kernel.

2. Added the below code snippet for avoiding the stack overflow

while writing data to the dataFlash. I attached the file for your

reference.

  static void *adjust_buffer_location(struct device *dev, void *buf) {

         if (likely(buf < high_memory)) {

          return buf;

          }

          else

          {

                  struct page *pg;

  

                  pg = vmalloc_to_page(buf);

                  if (pg == 0)

                  {

                          dev_err(dev, "failed to vmalloc_to_page\n");

return NULL;

                  }

          return page_address(pg) + ((size_t)buf & ~PAGE_MASK);

          }

  }

static int

  atmel_spi_dma_map_xfer(struct atmel_spi *as, struct spi_transfer *xfer) {

      ptr = adjust_buffer_location(dev,(void *)xfer->tx_buf);

                  if(ptr)

                  xfer->tx_dma = dma_map_single(dev,

                                  ptr, xfer->len,

                                  DMA_TO_DEVICE);

                  if (dma_mapping_error(dev, xfer->tx_dma))

                          return -ENOMEM;

          }

          if (xfer->rx_buf) {

                  ptr=adjust_buffer_location(dev, xfer->rx_buf);

                  if(ptr)

                  xfer->rx_dma = dma_map_single(dev,

                                  ptr, xfer->len,

                                  DMA_FROM_DEVICE);

  }

Could you please help any one on this issue.

Regards
Samba