Skip to contentSkip to conversation

i2c-mux-gpio: use deferred probing

PATCH In review Ionut Nicu 2 participants 2 messages Oct 9, 2013

Subsystems (3)
lore
Share & tools
lore

Ionut Nicu

author
#0 lore raw

PATCH 1/2 i2c-mux-gpio: use deferred probing

If the i2c-parent bus driver is not loaded, returning -ENODEV will force people to unload and then reload the module again to get it working.

---
 drivers/i2c/muxes/i2c-mux-gpio.c |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)
drivers/i2c/muxes/i2c-mux-gpio.c +2 -2
index 5d4a99b..ff184eb 100644
@@ -79,7 +79,7 @@ static int i2c_mux_gpio_probe_dt(struct gpiomux *mux,
 	adapter = of_find_i2c_adapter_by_node(adapter_np);
 	if (!adapter) {
 		dev_err(&pdev->dev, "Cannot find parent bus\n");
-		return -ENODEV;
+		return -EPROBE_DEFER;
 	}
 	mux->data.parent = i2c_adapter_id(adapter);
 	put_device(&adapter->dev);
@@ -177,7 +177,7 @@ static int i2c_mux_gpio_probe(struct platform_device *pdev)
 	if (!parent) {
 		dev_err(&pdev->dev, "Parent adapter (%d) not found\n",
 			mux->data.parent);
-		return -ENODEV;
+		return -EPROBE_DEFER;
 	}
 
 	mux->parent = parent;
Signature · 1 line
1.7.1
maintainer Acked-by on v1 1/2
#1 lore raw
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line

"IN" == Ionut Nicu <[email protected]> writes:

IN> If the i2c-parent bus driver is not loaded, returning IN> -ENODEV will force people to unload and then reload the IN> module again to get it working.

IN> Signed-off-by: Ionut Nicu <[email protected]>

--
Sorry about disclaimer - It's out of my control.
Bye, Peter Korsgaard
This message is subject to the following terms and conditions: MAIL DISCLAIMER<http://www.barco.com/en/maildisclaimer>