HDQ 1 Wire on AM43x
Hi,
I am trying to cleanup and use HDQ 1wire on AM43x with 3.12-rc6 kernel.
Slave device connected on my board is DS18B20, for which I have enabled the w1_therm.c driver. I populated the required hwmod entries and the log obtained is inlined[1].
Is there any way to test this out?
In some older thread, I saw that there is some discussion on some 'hdq idle fixes' done to get the hdq working. ?
I see a lot of sys entires, but all looks to be the attributes and could not figure out any slave where I can 'cat' the temperature data.
Do I need to enable anything more apart from what my below configs looks like:
#CONFIG_W1=yCONFIG_W1_CON=y
#
# 1-wire Bus Masters
#
# CONFIG_W1_MASTER_DS2490 is not set
# CONFIG_W1_MASTER_DS2482 is not set
# CONFIG_W1_MASTER_DS1WM is not set
# CONFIG_W1_MASTER_GPIO is not setCONFIG_HDQ_MASTER_OMAP=y
#
# 1-wire Slaves
#CONFIG_W1_SLAVE_THERM=y
Thanks,
Sourav
[1]:
Starting kernel ...
[ 0.000000] Booting Linux on physical CPU 0x0 [ 0.000000] Linux version 3.12.0-67367-g2d1978c-dirty (a0131647@a0131647) (gcc version 4.7.3 20130226 (prerelease) (crosstool-NG linaro-1.13.1-4.7-2013.03 [ 0.000000] CPU: ARMv7 Processor [412fc09a] revision 10 (ARMv7), cr=10c53c7d [ 0.000000] CPU: PIPT / VIPT nonaliasing data cache, VIPT aliasing instruction cache [ 0.000000] Machine: Generic AM43 (Flattened Device Tree), model: TI AM43x EPOS EVM [ 0.000000] cma: CMA: reserved 16 MiB at 9e800000 [ 0.000000] Memory policy: ECC disabled, Data cache writeback [ 0.000000] CPU: All CPU(s) started in SVC mode. [ 0.000000] AM437x ES1.0 (sgx neon ) [ 0.000000] PERCPU: Embedded 9 pages/cpu @c12c9000 s14656 r8192 d14016 u36864 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 129280 [ 0.000000] Kernel command line: root=/dev/ram0 rw mem=512M console=ttyO0,115200n8 initrd=0x82000000,20M ramdisk_size=20480 no_console_suspend [ 0.000000] PID hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Dentry cache hash table entries: 65536 (order: 6, 262144 bytes) [ 0.000000] Inode-cache hash table entries: 32768 (order: 5, 131072 bytes) [ 0.000000] Memory: 464604K/521216K available (6012K kernel code, 690K rwdata, 2340K rodata, 426K init, 5536K bss, 56612K reserved, 0K highmem) [ 0.000000] Virtual kernel memory layout: [ 0.000000] vector : 0xffff0000 - 0xffff1000 ( 4 kB) [ 0.000000] fixmap : 0xfff00000 - 0xfffe0000 ( 896 kB) [ 0.000000] vmalloc : 0xe0800000 - 0xff000000 ( 488 MB) [ 0.000000] lowmem : 0xc0000000 - 0xe0000000 ( 512 MB) [ 0.000000] pkmap : 0xbfe00000 - 0xc0000000 ( 2 MB) [ 0.000000] modules : 0xbf000000 - 0xbfe00000 ( 14 MB) [ 0.000000] .text : 0xc0008000 - 0xc083058c (8354 kB) [ 0.000000] .init : 0xc0831000 - 0xc089b940 ( 427 kB) [ 0.000000] .data : 0xc089c000 - 0xc0948b20 ( 691 kB) [ 0.000000] .bss : 0xc0948b20 - 0xc0eb0f00 (5537 kB) [ 0.000000] Hierarchical RCU implementation. [ 0.000000] RCU restricting CPUs from NR_CPUS=2 to nr_cpu_ids=1. [ 0.000000] NR_IRQS:16 nr_irqs:16 16 [ 0.000000] GIC CPU mask not found - kernel will fail to boot. [ 0.000000] GIC CPU mask not found - kernel will fail to boot. [ 0.000000] OMAP clockevent source: timer1 at 32786 Hz [ 0.000000] sched_clock: 32 bits at 32kHz, resolution 30517ns, wraps every 131071999ms [ 0.000000] OMAP clocksource: 32k_counter at 32768 Hz [ 0.000000] Console: colour dummy device 80x30
.....
[ 2.861450] Driver for 1-wire Dallas network protocol. [ 2.878417] omap_hdq 48347000.hdq: OMAP HDQ Hardware Rev 0.:. Driver in Interrupt mode [ 3.250061] w1_master_driver w1_bus_master1: Family 1 for 01.000000000000.3d is not registered.
[ 3.262054] omap_wdt: OMAP Watchdog Timer Rev 0x01: initial timeout 60 sec [ 3.275054] edma-dma-engine edma-dma-engine.0: allocated channel for 0:25 [ 3.282073] edma-dma-engine edma-dma-engine.0: allocated channel for 0:24 [ 3.336029] ledtrig-cpu: registered to indicate activity on CPUs [ 3.342712] edma-dma-engine edma-dma-engine.0: allocated channel for 0:36 [ 3.349639] omap-sham 53100000.sham: hw accel on OMAP rev 0.0 [ 3.364746] omap-aes 53501000.aes: OMAP AES hw accel rev: 0.1 [ 3.370758] edma-dma-engine edma-dma-engine.0: allocated channel for 0:5
......
[ 3.675811] platform connector.6: Driver connector-hdmi requests probe deferral [ 3.687438] drivers/rtc/hctosys.c: unable to open rtc device (rtc0) [ 3.712982] RAMDISK: ext2 filesystem found at block 0 [ 3.718017] RAMDISK: Loading 15360KiB [1 disk] into ram disk... [ 3.724517] connector-hdmi connector.6: failed to find video source [ 3.730957] platform connector.6: Driver connector-hdmi requests probe deferral done. [ 4.392822] EXT2-fs (ram0): warning: mounting unchecked fs, running e2fsck is recommended [ 4.401641] VFS: Mounted root (ext2 filesystem) on device 1:0. [ 4.408569] devtmpfs: mounted [ 4.412353] Freeing unused kernel memory: 424K (c0831000 - c089b000)
Mounting proc : OK
Mounting sysfs : OK
Mounting /dev : OK
Creating local mdev devices
umount: can't umount /mnt/mmc: Invalid argument
***********************************************
Starting System Init for: Generic AM43 (Flattened Device Tree)
Release: 3.12.0-67367-g2d1978c-dirty
***********************************************
Saving kernel ring buffer : OK
Mounting devpts : OK
Setting up networking
Configuring lo : OK
Configuring eth0 : ifup: can't open '/etc/network/interfaces': No such file or directory Failed
Starting syslogd : OK
Starting klogd : OK
Mounting filesystems : OK
Mounting Debug filesystem : OK
Please press Enter to activate this console.
/ #
/ # cd /
/ #
/ #
/ # cd /sys/bus//sys/bus # ls
clockevents event_source mdio_bus scsi soc w1 clocksource hid mmc sdio spi workqueue cpu i2c platform serio usb
/sys/bus # cd w1//sys/bus/w1 # ls
devices drivers_autoprobe uevent
drivers drivers_probe/sys/bus/w1 # cd devices//sys/bus/w1/devices # ls
01-000000000000 w1_bus_master1/sys/bus/w1/devices # cd w1_bus_master1//sys/devices/w1_bus_master1 # ls
01-000000000000 w1_master_attempts w1_master_search driver w1_master_max_slave_count w1_master_slave_count power w1_master_name w1_master_slaves subsystem w1_master_pointer w1_master_timeout uevent w1_master_pullup w1_master_add w1_master_remove
/sys/devices/w1_bus_master1 # cd .. /sys/bus/w1/devices # ls
01-000000000000 w1_bus_master1 /sys/bus/w1/devices # cd ../sys/bus/w1 # ls
devices drivers_autoprobe uevent
drivers drivers_probe/sys/bus/w1 # cd drivers//sys/bus/w1/drivers # lsw1_master_driver w1_slave_driver /sys/bus/w1/drivers # cd w1_master_driver/ /sys/bus/w1/drivers/w1_master_driver # ls
bind uevent unbind w1_bus_master1/sys/bus/w1/drivers/w1_master_driver # cd w1_bus_master1/ /sys/devices/w1_bus_master1 # ls
01-000000000000 w1_master_attempts w1_master_search driver w1_master_max_slave_count w1_master_slave_count power w1_master_name w1_master_slaves subsystem w1_master_pointer w1_master_timeout uevent w1_master_pullup w1_master_add w1_master_remove
/sys/devices/w1_bus_master1 # cd .. /sys/bus/w1/drivers/w1_master_driver # cd .. /sys/bus/w1/drivers # lsw1_master_driver w1_slave_driver /sys/bus/w1/drivers # cd w1_slave_driver/ /sys/bus/w1/drivers/w1_slave_driver # ls
01-000000000000 bind uevent unbind/sys/bus/w1/drivers/w1_slave_driver # cd 01-000000000000/ /sys/devices/w1_bus_master1/01-000000000000 # ls
driver id name power rw subsystem uevent/sys/devices/w1_bus_master1/01-000000000000 # /sys/devices/w1_bus_master1/01-000000000000 # /sys/devices/w1_bus_master1/01-000000000000 # cd .. /sys/bus/w1/drivers/w1_slave_driver # cd
/ # cd /sys/class//sys/class # ls
ata_device extcon input mmc_host rtc ubi ata_link firmware lcd mtd scsi_device udc ata_port gpio leds net scsi_disk usbmon backlight graphics mbox phy scsi_host vc bdi hwmon mdio_bus power_supply spi_master vtconsole block i2c-adapter mem pwm thermal watchdog dma i2c-dev misc regulator tty
/sys/class # cd ..
/sys # cd ..
/ #