Skip to contentSkip to conversation

xhci_hcd debugging status, please?

DISCUSSION Udo van den Heuvel 2 participants 2 messages Dec 8, 2013 – Dec 9, 2013

lore
Share & tools
lore
#0 lore raw

Hello,

Can someone please summarise the status of the xhci_hcd debugging I found after booting into 3.12.2?
I did not see these messages before and I do not yet understand the added value for a mere user of this exciting xhci technology. Can we please have them go away if really there's noting really wrong? See below for a small part of the stream of stuff that was started.

Kind regards,
Udo

[336894.944861] xhci_hcd 0000:00:10.1: Removing canceled TD starting at
0x25f450 (dma).
[336894.944866] xhci_hcd 0000:00:10.1: TRB to noop at offset 0x25f450
[336894.944885] xhci_hcd 0000:00:10.1: Cancel URB ffff8802342fa080, dev
1.1.4, ep 0x81, starting at offset 0x25f460
[336894.944890] xhci_hcd 0000:00:10.1: // Ding dong!
[336894.944977] xhci_hcd 0000:00:10.1: Removing canceled TD starting at
0x25f460 (dma).
[336894.944981] xhci_hcd 0000:00:10.1: TRB to noop at offset 0x25f460
#1 lore raw
Quoted 8 lines · Udo van den Heuvel

Hello,

Can someone please summarise the status of the xhci_hcd debugging I found after booting into 3.12.2?
I did not see these messages before and I do not yet understand the added value for a mere user of this exciting xhci technology. Can we please have them go away if really there's noting really wrong? See below for a small part of the stream of stuff that was started.

You have XHCI debugging on. This is most likely a side effect of teh switch to dynamic debugging in 3.12. But this should be discussed on linux-usb.

HTH
Oliver