Skip to contentSkip to conversation

iio and jack - 1MHz sample rate success

Jack-Devel Stéphane Letz 1 participant 1 message Feb 12, 2014 1 message not in the archive IIO

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 15 lines · Matt Flax

I have implemented the jack2 iio driver and have done a couple of tests.

In a preliminary finding, waiting for more time to test and re-test, I have had success.
I don't see any overruns reported (when setup properly), and I haven't put a signal through the system to highlight any un-reported overruns. Next week I will look into this more.

Firstly I would like to say that writing a driver for jack2 is a little difficult because there is not much documentation ... at least I couldn't find simple information. Some inline src doc would be good ... mind you, I could have put more into my driver as well :)

On the system with IIO devices I ran :
jackd -iio

I then setup and ran netjack on both computers.

On the other computer I used :
jack_capture -c 2 -p system:capture*

Quoted 8 lines

... wahlah ... it worked ! with an MTU of 1500. Thats 2 channels @ 1 MHz

Everything reporting 1MHz sample rates and so on a so forth, no xruns and the wav file looked like what I expected ...

When I tried to record 4 channels @ 1 MHz, I had to increase the MTU to 6000 to get rid of xruns on the ARM core. But still ... 4 channels @ 1MHz over a network ... pretty good start !

I would like to integrate my both of my iio branchs into the jack1 and jack2 repos, but for now I have forked the jack2 repo here :
https://github.com/flatmax/jack2/tree/iio

When ready, do a "merge request".

Quoted 6 lines

I have some questions for other developers of jack2. is it necessary to use :

    JackDriver::CycleTakeBeginTime();
and
    JackDriver::CycleTakeEndTime();

Sure: this code is used to take "timestamps" at the beginning and end of driver cycle, so that DSP CPU consumption can be computed later on.

Stéphane