Skip to contentSkip to conversation

add support for the R-Car H2 and M2 xHCI controllers

PATCH Superseded Yoshihiro Shimoda 1 participant 1 message May 19, 2014 SuperH

v1 of 5 Superseded Latest is v5 →

lore
Share & tools
lore
#0 lore raw

cover add support for the R-Car H2 and M2 xHCI controllers

This patch set adds the USB xHCI support for the R-Car H2 and M2 SoCs. These SoCs use an xHCI but still need specific initialization, mainly to setup the firmware downloading and the specific registers.

This patch set depends on the following patches:

	http://marc.info/?l=linux-usb&m=140014937401793&w=2
	http://marc.info/?l=linux-usb&m=140014935801786&w=2
	http://marc.info/?l=linux-usb&m=140014933101775&w=2
	http://marc.info/?l=linux-usb&m=140014932301770&w=2

However, this patch set doesn't depend on the following patch because this patch set uses the "USB phy", not "phy":

	http://marc.info/?l=linux-usb&m=140025742005303&w=2

Yoshihiro Shimoda (3):
usb: host: xhci-plat: add xhci_plat_start()
usb: host: xhci-plat: add support for the R-Car H2 and M2 xHCI
controllers
Documentation: dt-bindings: update xhci-platform DT binding for R-Car
Gen2

 Documentation/devicetree/bindings/usb/usb-xhci.txt |    3 +-
 drivers/usb/host/Kconfig                           |    8 +
 drivers/usb/host/Makefile                          |    3 +
 drivers/usb/host/xhci-plat.c                       |   25 ++-
 drivers/usb/host/xhci-rcar.c                       |  187 ++++++++++++++++++++
 drivers/usb/host/xhci-rcar.h                       |   37 ++++
 6 files changed, 261 insertions(+), 2 deletions(-)
 create mode 100644 drivers/usb/host/xhci-rcar.c
 create mode 100644 drivers/usb/host/xhci-rcar.h
Signature · 5 lines
1.7.9.5
--
To unsubscribe from this list: send the line "unsubscribe linux-usb" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html