Skip to contentSkip to conversation

ARM: dts: r8a7790-lager: Add DVFS parameters into cpu0 node for r8a7790

PATCH Superseded Gaku Inami 1 participant 1 message May 29, 2014

Subsystems (2)

v1 of 2 Superseded Latest is v2 →

lore
Share & tools
lore

Gaku Inami

author
#0 lore raw

PATCH 1/7 ARM: dts: r8a7790-lager: Add DVFS parameters into cpu0 node for r8a7790

Add needed information inside CPU0 for the generic cpufreq-cpu0 driver.

- voltage-tolerance = 1%
It reflects the tolerance for the CPU voltage defined inside the OPP table. Due to the lack of proper OPP definition, use an arbitrary safe value.
- clock-latency = 300 us
Approximate worst-case latency to do a full DVFS transition for every OPPs. Due to the lack of HW information, use an arbitrary safe value.
Note: The term transition-latency will be more accurate to define this value since the clock transition latency is not the only parameter that will define the overall DVFS transition.
- operating-points = < kHz - uV >
List of 6 operating points. All of them are using the same voltage since the valid Vmin voltage is not documented in the HW spec.
- clocks
phandle to the CPU clock source. This clock source is used for all the 4 CortexA15 located inside the same cluster.

---
 arch/arm/boot/dts/r8a7790-lager.dts |    4 ++++
 arch/arm/boot/dts/r8a7790.dtsi      |   11 +++++++++++
 2 files changed, 15 insertions(+)
arch/arm/boot/dts/r8a7790-lager.dts +4 -0
index 9becef7..ab73ed0 100644
@@ -317,3 +317,7 @@
 	cd-gpios = <&gpio3 22 GPIO_ACTIVE_LOW>;
 	status = "okay";
 };
+
+&cpu0 {
+	cpu0-supply = <&vdd_dvfs>;
+};
arch/arm/boot/dts/r8a7790.dtsi +11 -0
index 7ff2960..921225f 100644
@@ -44,6 +44,17 @@
 			compatible = "arm,cortex-a15";
 			reg = <0>;
 			clock-frequency = <1300000000>;
+			voltage-tolerance = <1>; /* 1% */
+			clocks = <&cpg_clocks R8A7790_CLK_Z>;
+			clock-latency = <300000>; /* 300 us */
+
+			/* kHz - uV - OPPs unknown yet */
+			operating-points = <1300000 1000000>,
+					   <1150000 1000000>,
+					   < 975000 1000000>,
+					   < 770000 1000000>,
+					   < 650000 1000000>,
+					   < 325000 1000000>;
 		};
 
 		cpu1: cpu@1 {
Signature · 1 line
1.7.9.5