ATH10K set bitrates problem
Quoted 22 lines · Janusz Dziedzic
Quoted 10 lines · Frank Agius
I am unable to set the bitrates for devices using the ath10k driver, regardless of the arguments I pass:
# iw wlan0 set bitrates legacy-2.4 6 12 24 command failed: Invalid argument (-22) # iw dev wlan0 set bitrates mcs-2.4 10 command failed: Invalid argument (-22)Quoted 6 lines
The ath10k drivers were built from stable backports v3.15-rc1. I am using
firmware file firmware-2.bin_999.999.0.636Is this a known issue?
This is expected.
ath10k support only single rate setting (or single nss). So, please check commit message,
ath10k: addset_bitrate_maskcallback
Quoted 4 lines
Try this:
iw wlan0 set bitrates legacy-2.4 18 ht-mcs-2.4
iw wlan0 set bitrates legacy-2.4 ht-mcs-2.4 6
iw wlan0 set bitrates - back to default mask.
Thanks, using the bitrate option ht-mcs-2.4 instead of mcs-2.4 worked. Note that I did have to upgrade the iw tools package. The version I was using (3.11) does not have support for bitrate option ht-mcs. Version 3.15 of iw tools does support the new options.
frank agius
_______________________________________________
ath10k mailing list
[email protected]
http://lists.infradead.org/mailman/listinfo/ath10k