usb: renesas_usbhs: Add device tree bindings documentation
Subsystems (3)
PATCH v2 1/2 usb: renesas_usbhs: Add device tree bindings documentation
Document the device tree bindings for the Renesas USBHS controller.
Signed-off-by Yoshihiro Shimoda <[email protected]>
--- .../devicetree/bindings/usb/renesas_usbhs.txt | 24 ++++++++++++++++++++ 1 file changed, 24 insertions(+) create mode 100644 Documentation/devicetree/bindings/usb/renesas_usbhs.txt
Documentation/devicetree/bindings/usb/renesas_usbhs.txt new file +24 -0
@@ -0,0 +1,24 @@ +Renesas Electronics USBHS driver + +Required properties: + - compatible: Must contain one of the following: + - "renesas,usbhs-r8a7790" + - "renesas,usbhs-r8a7791" + - reg: Base address and length of the register for the USBHS + - interrupts: Interrupt specifier for the USBHS + - clocks: A list of phandle + clock specifier pairs + +Optional properties: + - renesas,buswait: Integer to use BUSWAIT register + - renesas,enable-gpio: A gpio specifier to check GPIO determining if USB + function should be enabled + - phys: phandle + phy specifier pair + - phy-names: must be "usb" + +Example: + usbhs: usb@e6590000 { + compatible = "renesas,usbhs-r8a7790"; + reg = <0 0xe6590000 0 0x100>; + interrupts = <0 107 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&mstp7_clks R8A7790_CLK_HSUSB>; + };
Signature · 6 lines
1.7.9.5 -- To unsubscribe from this list: send the line "unsubscribe linux-usb" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html