DCB Tx support in v1.2

Hi team,

Currently I am using DPDK version 1.2, for which can I configure VMDQ_DCB both in Rx/Tx Mq modes ?

In v1.2 I see only Rx MQ mode is defined but not Tx as below.
Does it mean application can only receive packets from multiple traffic classes but not transmit ? If yes, do I need to upgrade my DPDK to latest release ?

205 enum rte_eth_rx_mq_mode {
206 ETH_RSS = 0, /**< Default to RSS mode */
207 ETH_VMDQ_DCB /**< Use VMDQ+DCB to route traffic to queues */
208 };

However in later release v1.6 has both Rx & Tx MQ mode independently as shown below,

248 enum rte_eth_rx_mq_mode {
249 ETH_MQ_RX_NONE = 0, /**< None of DCB,RSS or VMDQ mode */
250

 251         ETH_MQ_RX_RSS,       /**< For RX side, only RSS is on */
 252         ETH_MQ_RX_DCB,       /**< For RX side,only DCB is on. */
 253         ETH_MQ_RX_DCB_RSS,   /**< Both DCB and RSS enable */
 254
 255         ETH_MQ_RX_VMDQ_ONLY, /**< Only VMDQ, no RSS nor DCB */
 256         ETH_MQ_RX_VMDQ_RSS,  /**< RSS mode with VMDQ */
 257         ETH_MQ_RX_VMDQ_DCB, /**< Use VMDQ+DCB to route traffic to 

queues */
258 ETH_MQ_RX_VMDQ_DCB_RSS, /**< Enable both VMDQ and DCB in
VMDq */
259 };

268 /**

 269  * A set of values to identify what method is to be used to transmit
 270  * packets using multi-TCs.
 271  */
 272 enum rte_eth_tx_mq_mode {
 273         ETH_MQ_TX_NONE    = 0,  /**< It is in neither DCB nor VT 
mode. */
 274         ETH_MQ_TX_DCB,          /**< For TX side,only DCB is on. */
 275         ETH_MQ_TX_VMDQ_DCB, /**< For TX side,both DCB and VT is on. */
 276         ETH_MQ_TX_VMDQ_ONLY,    /**< Only VT on, no DCB */

277 };

Thanks,
Sunil