Writing clocksource driver, tips?
Hello all,
currently i work on porting linux to Aplscale ASM9260,
most basic parts are done, now is the time for clocksource driver. I never did it before, so i need some beginner tips.
My current driver clocksource provide periodic events at 100Hz rate. But this hardvare can do more then it.
This SoC has 4 32bit-timer controller attached to 100MHz source. Each controller has 4 separate timer register each of them can be configure separately for scale, match and interrupt. 3 controllers can choice the tick source.
This controller looks similar to one found on NXP LPC1311, but looks like no similar hardware in drivers/clocksource.
For now i have fallowing questions:
- 1 timer can be used for clocksource other as clock_event_device, how can i use other 2 timers on same controller. and how can i use other 3 controllers?
- theoretically i can use clocksource_mmio_init to read directly timer_counter_register. Which scale should be used on it. 100MHz is probably too match.
- should clocksource provide interrupt on overflow or some kind of limit?
Signature · 2 lines
Regards, Oleksij
Quoted 3 lines · Oleksij Rempel
- 1 timer can be used for clocksource other as
clock_event_device, how can i use other 2 timers on same controller. and how can i use other 3 controllers?
All you need is two.
One for the clocksource (free running counter):
100MHz is fine, it gives the timekeeping code nice granularity. There is no need for a wrap around interrupt. The core code knows how to deal with it.
The second one is for the clock event device
Avoid a match timer if possible, it's a pain in the neck. Either a autoreloading timer for the periodic mode or a simple downcounting one for one shot mode is good enough.
The other timers are not of any value for Linux. Just leave them alone.
Thanks,
tglx