Invensense MPU6500 driver with Digital Motion Processor (DMP)
Hi Nathan/Ge,
I'm playing with Invensense MPU6500 device but I'm having problems receiving data when the DPM is enabled.
I've rebased the code from 3.4 [1] on top of the latest iio git tree. Without DMP enabled, I see interrupts arriving and I can read data from /dev/iio:device0.
I'm using the following sequence for test:
sysfs_dev=/sys/bus/iio/devices/iio:device0
#Write dmp fw
fw_loaded=cat ${sysfs_dev}/firmware_loaded
if [ $fw_loaded -eq 0 ]; then
fwtool write /bin/fw.bin
fi
#Enable accel
echo 0 > ${sysfs_dev}/buffer/enable
echo 200 > ${sysfs_dev}/sampling_frequency
echo 1 > ${sysfs_dev}/accel_fifo_enable
echo 1 > ${sysfs_dev}/accel_enable
echo 1 > ${sysfs_dev}/gyro_fifo_enable
echo 1 > ${sysfs_dev}/gyro_enable
#echo 1 > ${sysfs_dev}/master_enable
#Enable DMP
echo 1 > ${sysfs_dev}/dmp_on
echo 1 > ${sysfs_dev}/dmp_int_on
echo 1 > ${sysfs_dev}/dmp_event_int_on
echo 1 > ${sysfs_dev}/buffer/enable
cat /dev/iio\:device0
Now, the problem is that there is not interrupt triggered. Have you faced similar issues? Is there something wrong with the above sequence?
thanks,
Daniel.