(no subject)
Hi Benny,
the Terratec DMX Xfire has got one(1) codec chip:
C (that's the Crystal logo of cirrus logic)
4294-JQ EP
(ZTAHKE0109)
the following link says
"CS4294 CrystalClear 4channel
AC97"
http://www.plasma-online.de/index.html?content=http%3A//www.plasma-online.de/english/identify/picture/crystal.html
but i don't know which version of AC97...
Quoted 1 line
Look at your card physically, you may find the codec chips close to the DSP
chip.
Quoted 1 line
It would be great if you could do so.
Signature · 9 lines
GMX - Die Kommunikationsplattform im Internet. http://www.gmx.net ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf
Re: (Terratec DMX Xfire seems to not have any secondary CODEC)
Quoted 8 lines
the Terratec DMX Xfire has got one(1) codec chip:
C (that's the Crystal logo of cirrus logic)
4294-JQ EP
(ZTAHKE0109)
Quoted 7 lines
the following link says
"CS4294 CrystalClear 4channel
AC97"
http://www.plasma-online.de/index.html?content=http%3A//www.plasma-online.de/english/identify/picture/crystal.htmlbut i don't know which version of AC97...
That's a good explication why it dont detect the secondary codec.
I've been reading the DataSheet of the 4294, and the CODEC is equiped with two DAC's it's possible to address each DAC independently, in that way having 4 independent channels with one CODEC.
On the Hercules Game Theater XP (i believe) that the primary CODEC gives output to front L/R headphones L/R,
the secondary rear L/R , center and subwoofer. Which in theory should be 8 indpendent channels, but you may want
the same output in fron L/R and headphones L/R, the 4294 CODEC is default programmed to give the same output in
both channels (so far I can understand from the bloody spec.) which explain why the headphones works fine with the Hercules Game Theater XP, but dont explain why I got no output from center and subwoofer, and dont explain why there is not any output from all 4 channels on the Terratec board.
In conclusion, with the Terratec board we need to a different setup on the CODEC, and probably some different setup on the DSP to make the 4 channels work. And hopefully there is no unkown GPIO to take care of.
/Benny
-------------------------------------------------------
This sf.net email is sponsored by:ThinkGeek
Welcome to geek heaven.
http://thinkgeek.com/sf