btrfs-progs: allow CFLAGS specification in new build
Subsystems (2)
PATCH 1/1 btrfs-progs: allow CFLAGS specification in new build
Disclaimer: I am not an auto$FOO expert by any means.
But I could find no way to specify additional CFLAGS, and I think that this is because they are hard-coded in configure.ac.
The below works for me, but I don't know if it's the right solution...
Signed-off-by Eric Sandeen <[email protected]>
---
Makefile.in +1 -0
@@ -12,6 +12,7 @@ DISABLE_BTRFSCONVERT = @DISABLE_BTRFSCONVERT@ # Non-static compilation flags CFLAGS = @CFLAGS@ \ + -g -O1 \ -include config.h -Wall \ -D_FILE_OFFSET_BITS=64 -DBTRFS_FLAT_INCLUDES \ -D_XOPEN_SOURCE=700 \
configure.ac +0 -2
@@ -8,8 +8,6 @@ LIBBTRFS_MAJOR=0 LIBBTRFS_MINOR=1 LIBBTRFS_PATCHLEVEL=1 -CFLAGS="-g -O1" - AC_PREREQ([2.60]) AC_CONFIG_AUX_DIR([config])
Quoted 6 lines · Eric Sandeen
Disclaimer: I am not an auto$FOO expert by any means.
But I could find no way to specify additional CFLAGS, and I think that this is because they are hard-coded in configure.ac.
The below works for me, but I don't know if it's the right solution...
gah, looking at the wrong branch in git. Never mind.
-Eric