Skip to contentSkip to conversation

Fault Address from sigcontext for the various archs

DISCUSSION Camm Maguire 1 participant 1 message Mar 5, 2001

lore
Share & tools
lore
#0 lore raw

Greetings! I'm trying to assist in porting gcl to the various Linux archs, and the code as is needs the fault address from struct sigcontext. i386 and m68k work, with solutions shown below. What about the other archs? Where can I find the fault address around this struct?

Thanks!

=============================================================================
i386
=============================================================================

#define GET_FAULT_ADDR(sig,code,sv,a) \
    ((void *)(((struct sigcontext_struct *)(&code))->cr2))     
=============================================================================
m68k
=============================================================================
#define GET_FAULT_ADDR(sig,code,sv,a) \
    ({	\
		struct sigcontext *scp = (struct sigcontext *)(sv);\
		int format = (scp->sc_formatvec >> 12) & 0xf;\
		unsigned long *framedata = (unsigned long *)(scp + 1);\
		unsigned long ea;\
		if (format == 0xa || format == 0xb)\
			/* 68020/030 */\
			ea = framedata[2];\
		else if (format == 7)\
			/* 68040 */\
			ea = framedata[3];\
		else if (format == 4) {\
			/* 68060 */\
			ea = framedata[0];\
			if (framedata[1] & 0x08000000)\
				/* correct addr on misaligned access */\
				ea = (ea+4095)&(~4095);\
		}\
		ea;\
	})

=============================================================================

Signature · 3 lines
Camm Maguire			     			[email protected]
==========================================================================
"The earth is but one country, and mankind its citizens."  --  Baha'u'llah