Using ath10k in ad-hoc mode
Dear all,
Recently I have bought some compex 802.11ac cards and I would like to communicate them creating a adhoc network. The initial setup would be to have three pc's in a "line" 1-2-3 and perform ping 1 to 3 passing through the 2 pc.
I have read in the mailing list that the adhoc mode is possible using the candela firmware, isn't it?
I am a newbie working with ath10k driver and, I would like to know if someone could help me or provide hints/material on how to configure these cards to work in the adhoc mode and making possible to ping between them. I suppose this process would be done in two steps:
1)configure cards to work in adhoc mode.
2)configure routes and paths in the card.
I've trying to look for this in the mailing list but I have found confusing information, so any hint will be welcome.
Thank you very much for your time and attention,
With kind regards,
Signature · 16 lines
Jorge Baranda Research Engineer, MSc [email protected] Centre Tecnològic de Telecomunicacions de Catalunya (CTTC) Av. Carl Friedrich Gauss, 7 08860 Castelldefels, Barcelona (Spain) Tel: +34 93 645 29 00 Ext: 2171 Fax. +34 93 645 29 01 www.cttc.es _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k