Skip to contentSkip to conversation

spi: s3c64xx: extend driver to make full use of runtime PM autosuspend

PATCH In review Heiner Kallweit 2 participants 3 messages Aug 19, 2015 – Aug 20, 2015 2 messages not in the archive

Subsystems (3)
SPI Arm Samsung Exynos Samsung SPI drivers
lore
Share & tools
lore

Heiner Kallweit

author
#0 lore raw

PATCH 2/3 spi: s3c64xx: extend driver to make full use of runtime PM autosuspend

Extend the driver to make full use of runtime PM autosuspend. Before only the SPI core was instructed to use autosuspend by setting master->auto_runtime_pm. Nevertheless due to the missing pm_runtime_use_autosuspend call autosuspend wasn't active.

Signed-off-by Heiner Kallweit <[email protected]>
---
 drivers/spi/spi-s3c64xx.c | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)
drivers/spi/spi-s3c64xx.c +10 -2
index 8a6ab88..8365c88 100644
@@ -32,6 +32,7 @@
 #define MAX_SPI_PORTS		6
 #define S3C64XX_SPI_QUIRK_POLL		(1 << 0)
 #define S3C64XX_SPI_QUIRK_CS_AUTO	(1 << 1)
+#define AUTOSUSPEND_TIMEOUT	2000
 
 /* Registers and bit-fields */
 

@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
 		}
 	}
 
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
 	return 0;
 
 setup_exit:
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	/* setup() returns with device de-selected */
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);

@@ -1180,6 +1183,8 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 	       S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN,
 	       sdd->regs + S3C64XX_SPI_INT_EN);
 
+	pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT);
+	pm_runtime_use_autosuspend(&pdev->dev);
 	pm_runtime_set_active(&pdev->dev);
 	pm_runtime_enable(&pdev->dev);
 

@@ -1195,6 +1200,9 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 					mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1,
 					sdd->rx_dma.dmach, sdd->tx_dma.dmach);
 
+	pm_runtime_mark_last_busy(&pdev->dev);
+	pm_runtime_autosuspend(&pdev->dev);
+
 	return 0;
 
 err4:
Signature · 6 lines
2.5.0

--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in
the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
#2 lore raw
In reply to a message not in the archive
Quoted 9 lines · Heiner Kallweit

Extend the driver to make full use of runtime PM autosuspend. Before only the SPI core was instructed to use autosuspend by setting master->auto_runtime_pm. Nevertheless due to the missing pm_runtime_use_autosuspend call autosuspend wasn't active.

Signed-off-by Heiner Kallweit <[email protected]>
---
 drivers/spi/spi-s3c64xx.c | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)

I am a little bit confused... it's the same patch? It's not marked as resend, not marked as v2 and there is no changelog...

Best regards,
Krzysztof

Quoted 42 lines
drivers/spi/spi-s3c64xx.c +7 -2
index 8a6ab88..8365c88 100644
@@ -32,6 +32,7 @@
 #define MAX_SPI_PORTS		6
 #define S3C64XX_SPI_QUIRK_POLL		(1 << 0)
 #define S3C64XX_SPI_QUIRK_CS_AUTO	(1 << 1)
+#define AUTOSUSPEND_TIMEOUT	2000
 
 /* Registers and bit-fields */
 

@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
 		}
 	}
 
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
 	return 0;
 
 setup_exit:
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	/* setup() returns with device de-selected */
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);

@@ -1180,6 +1183,8 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 	       S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN,
 	       sdd->regs + S3C64XX_SPI_INT_EN);
 
+	pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT);
+	pm_runtime_use_autosuspend(&pdev->dev);
 	pm_runtime_set_active(&pdev->dev);
 	pm_runtime_enable(&pdev->dev);

drivers/spi/spi-s3c64xx.c static int s3c64xx_spi_probe(struct platform_device *pdev) · line 1208

Quoted 9 lines
drivers/spi/spi-s3c64xx.c +3 -0
@@ -1195,6 +1200,9 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 					mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1,
 					sdd->rx_dma.dmach, sdd->tx_dma.dmach);
 
+	pm_runtime_mark_last_busy(&pdev->dev);
+	pm_runtime_autosuspend(&pdev->dev);
+
 	return 0;
 
 err4:

--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html

author
#4 lore raw
In reply to a message not in the archive

Am 20.08.2015 um 01:46 schrieb Krzysztof Kozlowski:

Quoted 12 lines · Heiner Kallweit
Quoted 9 lines

Extend the driver to make full use of runtime PM autosuspend. Before only the SPI core was instructed to use autosuspend by setting master->auto_runtime_pm. Nevertheless due to the missing pm_runtime_use_autosuspend call autosuspend wasn't active.

Signed-off-by Heiner Kallweit <[email protected]>
---
 drivers/spi/spi-s3c64xx.c | 12 ++++++++++--
 1 file changed, 10 insertions(+), 2 deletions(-)
Quoted 5 lines

I am a little bit confused... it's the same patch? It's not marked as resend, not marked as v2 and there is no changelog...

Best regards,
Krzysztof

The structure of the patchset significantly changed, therefore I didn't mark it as v2. But you're right, should have done it.
Will send a v2 incl. the changes based on your remarks + changelog.

Regards, Heiner

Quoted 44 lines
Quoted 44 lines
drivers/spi/spi-s3c64xx.c +7 -2
index 8a6ab88..8365c88 100644
@@ -32,6 +32,7 @@
 #define MAX_SPI_PORTS		6
 #define S3C64XX_SPI_QUIRK_POLL		(1 << 0)
 #define S3C64XX_SPI_QUIRK_CS_AUTO	(1 << 1)
+#define AUTOSUSPEND_TIMEOUT	2000
 
 /* Registers and bit-fields */
 

@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
 		}
 	}
 
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
 	return 0;
 
 setup_exit:
-	pm_runtime_put(&sdd->pdev->dev);
+	pm_runtime_mark_last_busy(&sdd->pdev->dev);
+	pm_runtime_put_autosuspend(&sdd->pdev->dev);
 	/* setup() returns with device de-selected */
 	if (!(sdd->port_conf->quirks & S3C64XX_SPI_QUIRK_CS_AUTO))
 		writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);

@@ -1180,6 +1183,8 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 	       S3C64XX_SPI_INT_TX_OVERRUN_EN | S3C64XX_SPI_INT_TX_UNDERRUN_EN,
 	       sdd->regs + S3C64XX_SPI_INT_EN);
 
+	pm_runtime_set_autosuspend_delay(&pdev->dev, AUTOSUSPEND_TIMEOUT);
+	pm_runtime_use_autosuspend(&pdev->dev);
 	pm_runtime_set_active(&pdev->dev);
 	pm_runtime_enable(&pdev->dev);
 

@@ -1195,6 +1200,9 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
 					mem_res, (FIFO_LVL_MASK(sdd) >> 1) + 1,
 					sdd->rx_dma.dmach, sdd->tx_dma.dmach);
Quoted 9 lines

drivers/spi/spi-s3c64xx.c static int s3c64xx_spi_probe(struct platform_device *pdev) · line 1208

Quoted 7 lines
drivers/spi/spi-s3c64xx.c +3 -0
+	pm_runtime_mark_last_busy(&pdev->dev);
+	pm_runtime_autosuspend(&pdev->dev);
+
 	return 0;
 
 err4:

--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html