spi: s3c64xx: extend driver to make full use of runtime PM autosuspend
Subsystems (3)
PATCH RESEND v2 2/4 spi: s3c64xx: extend driver to make full use of runtime PM autosuspend
Extend the driver to make full use of runtime PM autosuspend. Before only the SPI core was instructed to use autosuspend by setting master->auto_runtime_pm. Nevertheless due to the missing pm_runtime_use_autosuspend call autosuspend wasn't active.
---
Changed:
- Let driver autosuspend also after leaving s3c64xx_spi_setup
- Enable runtime PM earlier in s3c64xx_spi_probe and prevent suspending in the relevant part of probe
v2:
- Don't init runtime PM before the driver has a reference to the clocks
drivers/spi/spi-s3c64xx.c | 26 ++++++++++++++++++-------- 1 file changed, 18 insertions(+), 8 deletions(-)
drivers/spi/spi-s3c64xx.c +18 -8
@@ -32,6 +32,7 @@#define MAX_SPI_PORTS 6#define S3C64XX_SPI_QUIRK_POLL (1 << 0)#define S3C64XX_SPI_QUIRK_CS_AUTO (1 << 1) +#define AUTOSUSPEND_TIMEOUT 2000/* Registers and bit-fields */
@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi) } } -pm_runtime_put (&sdd->pdev->dev); +pm_runtime_mark_last_busy (&sdd->pdev->dev); +pm_runtime_put_autosuspend (&sdd->pdev->dev);if (!(sdd->port_conf->quirks &S3C64XX_SPI_QUIRK_CS_AUTO ))writel (S3C64XX_SPI_SLAVE_SIG_INACT , sdd->regs +S3C64XX_SPI_SLAVE_SEL );return 0 ; setup_exit: -pm_runtime_put (&sdd->pdev->dev); +pm_runtime_mark_last_busy (&sdd->pdev->dev); +pm_runtime_put_autosuspend (&sdd->pdev->dev);/* setup() returns with device de-selected */ if (!(sdd->port_conf->quirks &S3C64XX_SPI_QUIRK_CS_AUTO ))writel (S3C64XX_SPI_SLAVE_SIG_INACT , sdd->regs +S3C64XX_SPI_SLAVE_SEL );
@@ -1162,6 +1165,12 @@ static int s3c64xx_spi_probe(struct platform_device *pdev) goto err2; } +pm_runtime_set_autosuspend_delay (&pdev->dev,AUTOSUSPEND_TIMEOUT ); +pm_runtime_use_autosuspend (&pdev->dev); +pm_runtime_set_active (&pdev->dev); +pm_runtime_enable (&pdev->dev); +pm_runtime_get_sync (&pdev->dev); +/* Setup Deufult Mode */ s3c64xx_spi_hwinit (sdd, sdd->port_id);
@@ -1180,13 +1189,10 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)S3C64XX_SPI_INT_TX_OVERRUN_EN |S3C64XX_SPI_INT_TX_UNDERRUN_EN , sdd->regs + S3C64XX_SPI_INT_EN); -pm_runtime_set_active (&pdev->dev); -pm_runtime_enable (&pdev->dev); - ret =devm_spi_register_master (&pdev->dev, master);if (ret !=0 ) {dev_err (&pdev->dev,"cannot register SPI master: %d\n" , ret); - goto err4; + goto err3; } dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with %d Slaves attached\n",
@@ -1195,12 +1201,16 @@ static int s3c64xx_spi_probe(struct platform_device *pdev) mem_res, (FIFO_LVL_MASK (sdd) >>1 ) +1 , sdd->rx_dma.dmach, sdd->tx_dma.dmach); +pm_runtime_mark_last_busy (&pdev->dev); +pm_runtime_put_autosuspend (&pdev->dev); +return 0 ; -err4: +err3: +pm_runtime_put_noidle (&pdev->dev);pm_runtime_disable (&pdev->dev);pm_runtime_set_suspended (&pdev->dev); -err3: +clk_disable_unprepare (sdd->src_clk); err2:clk_disable_unprepare (sdd->clk);
Signature · 1 line
2.5.0
Krzysztof Kozlowski
Reviewed-byW dniu 22.08.2015 o 02:29, Heiner Kallweit pisze:
Quoted 14 lines
Extend the driver to make full use of runtime PM autosuspend. Before only the SPI core was instructed to use autosuspend by setting
master->auto_runtime_pm. Nevertheless due to the missingpm_runtime_use_autosuspendcall autosuspend wasn't active.Signed-off-by Heiner Kallweit <[email protected]>---
Changed:
- Let driver autosuspend also after leavings3c64xx_spi_setup
- Enable runtime PM earlier ins3c64xx_spi_probeand prevent suspending in the relevant part of probe
v2:
- Don't init runtime PM before the driver has a reference to the clocks
Quoted 2 lines
drivers/spi/spi-s3c64xx.c | 26 ++++++++++++++++++-------- 1 file changed, 18 insertions(+), 8 deletions(-)
Looks good to me now:
Best regards,
Krzysztof
--
To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html
Applied "spi: s3c64xx: extend driver to make full use of runtime PM autosuspend" to the spi tree
In reply to a message not in the archiveThe patch
spi: s3c64xx: extend driver to make full use of runtime PM autosuspend
has been applied to the spi tree at
git://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git
All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.
You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.
If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.
Please add any relevant lists and maintainers to the CCs when replying to this mail.
Thanks,
Mark
Quoted 1 line
From
483867ee2070e045eb0a18fb7bb2f79d2433339fMon Sep 17 00:00:00 2001
From: Heiner Kallweit <[email protected]>
Date: Thu, 3 Sep 2015 22:39:36 +0200
Subject: [PATCH] spi: s3c64xx: extend driver to make full use of runtime PM
autosuspend
Extend the driver to make full use of runtime PM autosuspend. Before only the SPI core was instructed to use autosuspend by setting master->auto_runtime_pm. Nevertheless due to the missing pm_runtime_use_autosuspend call autosuspend wasn't active.
--- drivers/spi/spi-s3c64xx.c | 26 ++++++++++++++++++-------- 1 file changed, 18 insertions(+), 8 deletions(-)
drivers/spi/spi-s3c64xx.c +18 -8
@@ -32,6 +32,7 @@#define MAX_SPI_PORTS 6#define S3C64XX_SPI_QUIRK_POLL (1 << 0)#define S3C64XX_SPI_QUIRK_CS_AUTO (1 << 1) +#define AUTOSUSPEND_TIMEOUT 2000/* Registers and bit-fields */
@@ -859,13 +860,15 @@ static int s3c64xx_spi_setup(struct spi_device *spi) } } -pm_runtime_put (&sdd->pdev->dev); +pm_runtime_mark_last_busy (&sdd->pdev->dev); +pm_runtime_put_autosuspend (&sdd->pdev->dev);if (!(sdd->port_conf->quirks &S3C64XX_SPI_QUIRK_CS_AUTO ))writel (S3C64XX_SPI_SLAVE_SIG_INACT , sdd->regs +S3C64XX_SPI_SLAVE_SEL );return 0 ; setup_exit: -pm_runtime_put (&sdd->pdev->dev); +pm_runtime_mark_last_busy (&sdd->pdev->dev); +pm_runtime_put_autosuspend (&sdd->pdev->dev);/* setup() returns with device de-selected */ if (!(sdd->port_conf->quirks &S3C64XX_SPI_QUIRK_CS_AUTO ))writel (S3C64XX_SPI_SLAVE_SIG_INACT , sdd->regs +S3C64XX_SPI_SLAVE_SEL );
@@ -1162,6 +1165,12 @@ static int s3c64xx_spi_probe(struct platform_device *pdev) goto err2; } +pm_runtime_set_autosuspend_delay (&pdev->dev,AUTOSUSPEND_TIMEOUT ); +pm_runtime_use_autosuspend (&pdev->dev); +pm_runtime_set_active (&pdev->dev); +pm_runtime_enable (&pdev->dev); +pm_runtime_get_sync (&pdev->dev); +/* Setup Deufult Mode */ s3c64xx_spi_hwinit (sdd, sdd->port_id);
@@ -1180,13 +1189,10 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)S3C64XX_SPI_INT_TX_OVERRUN_EN |S3C64XX_SPI_INT_TX_UNDERRUN_EN , sdd->regs + S3C64XX_SPI_INT_EN); -pm_runtime_set_active (&pdev->dev); -pm_runtime_enable (&pdev->dev); - ret =devm_spi_register_master (&pdev->dev, master);if (ret !=0 ) {dev_err (&pdev->dev,"cannot register SPI master: %d\n" , ret); - goto err4; + goto err3; } dev_dbg(&pdev->dev, "Samsung SoC SPI Driver loaded for Bus SPI-%d with %d Slaves attached\n",
@@ -1195,12 +1201,16 @@ static int s3c64xx_spi_probe(struct platform_device *pdev) mem_res, (FIFO_LVL_MASK (sdd) >>1 ) +1 , sdd->rx_dma.dmach, sdd->tx_dma.dmach); +pm_runtime_mark_last_busy (&pdev->dev); +pm_runtime_put_autosuspend (&pdev->dev); +return 0 ; -err4: +err3: +pm_runtime_put_noidle (&pdev->dev);pm_runtime_disable (&pdev->dev);pm_runtime_set_suspended (&pdev->dev); -err3: +clk_disable_unprepare (sdd->src_clk); err2:clk_disable_unprepare (sdd->clk);
Signature · 6 lines
2.5.0 -- To unsubscribe from this list: send the line "unsubscribe linux-spi" in the body of a message to [email protected] More majordomo info at http://vger.kernel.org/majordomo-info.html