iwlegacy and bridging iwl3945...? (sort of)
https://wireless.wiki.kernel.org/en/users/drivers/iwlegacy
('$ ethtool -i wlp16s0' says 'driver: iwl3945' but
https://wireless.wiki.kernel.org/en/users/drivers/iwl3945
links here
https://wireless.wiki.kernel.org/en/users/Drivers/iwlwifi
then here
https://wireless.wiki.kernel.org/en/users/drivers/iwlegacy
So, running fedora 21, I assume the above means my driver is iwlegacy)
Hello Folks,
I have a deceptively simply questions;
Will this iwlegacy driver driving iwl3945 hardware work as per this How To here:
https://wiki.debian.org/BridgeNetworkConnections#Bridging_with_a_wireless_NIC
?
That How To provides (to a novice) a comprehensive explanation to the problem of bridging a wireless connection that seems to be universal to all wireless connections. But, there are other explanations of the wireless bridging problem which make me suspicious it might not work...
Warning here:
http://www.linux-kvm.org/page/Networking#public_bridge
Explanation here:
http://www.linuxfoundation.org/collaborate/workgroups/networking/bridge#It_doesn.27t_work_with_my_Wireless_card.21
So, can I expect to be able to bridge my 802.11 connection to work with my KVM guests?
(I'm setting up an old laptop to run as a home server.)
Many thanks for your help.
Morgan.
Signature · 7 lines
Morgan Read UNITED KINGDOM <mailto:mstuffATreadDOTorgDOTnz> Confused about DRM? Get all the info you need at: http://drm.info/
Quoted 4 lines · Morgan Read
So, can I expect to be able to bridge my 802.11 connection to work with my KVM guests?
No, never over wireless, regardless of the driver.
(Unless you also control the software on the AP and can run openwrt or such and use the Linux-specific 4-addr mode)
johannes
Quoted 2 lines · Johannes Berg
Quoted 1 line · Morgan Read
...
Quoted 4 lines
(Unless you also control the software on the AP and can run openwrt or such and use the Linux-specific 4-addr mode)
Thanks for the follow up.
That's certainly a possibilty - I have in the past had Gargoyle on my router but, I hadn't installed it on my present router yet because it wasn't supported but, I see as of May the tplink c7 archer is supported... Perhaps it's time for an upgrade.
However, before I go down that route are any of the options for bonding, which again seem as if they would work, actually a reality?
http://www.codekoala.com/posts/bonding-eth0-and-wlan0-arch-linux/
https://docs.fedoraproject.org/en-US/Fedora/21/html/Networking_Guide/ch-Configure_Network_Bonding.html
Then would the example at the bottom of this page work:
https://docs.fedoraproject.org/en-US/Fedora/18/html/System_Administrators_Guide/s2-networkscripts-interfaces_network-bridge.html
That is, bridging the bonded interfaces?
This is the most appropriate set up for my use.
Many thanks
M
Signature · 7 lines
Morgan Read UNITED KINGDOM <mailto:mstuffATreadDOTorgDOTnz> Confused about DRM? Get all the info you need at: http://drm.info/
Quoted 4 lines
However, before I go down that route are any of the options for bonding, which again seem as if they would work, actually a reality?
I don't really know anything about bonding, sorry.
johannes