board: Add gpio and ethernet support to pic32mzdask board.
PATCH 14/18 board: Add gpio and ethernet support to pic32mzdask board.
Add GPIO and network (DHCP. BOOTP, TFTP protocol) support.
Signed-off-by Purna Chandra Mandal <[email protected]>
---
arch/mips/dts/pic32mzda.dtsi | 92 ++++++++++++++++++++++++++++++++++++++++++ arch/mips/dts/pic32mzda_sk.dts | 5 +++ configs/pic32mzdask_defconfig | 9 +++++ include/configs/pic32mzdask.h | 22 ++++++++++ 4 files changed, 128 insertions(+)
arch/mips/dts/pic32mzda.dtsi +92 -0
@@ -5,12 +5,26 @@ * SPDX-License-Identifier: GPL-2.0+ */ +#include <dt-bindings/gpio/gpio.h> #include <dt-bindings/interrupt-controller/irq.h> #include "skeleton.dtsi" / { compatible = "microchip,pic32mzda", "microchip,pic32mz"; + aliases { + gpio0 = &gpioA; + gpio1 = &gpioB; + gpio2 = &gpioC; + gpio3 = &gpioD; + gpio4 = &gpioE; + gpio5 = &gpioF; + gpio6 = &gpioG; + gpio7 = &gpioH; + gpio8 = &gpioJ; + gpio9 = &gpioK; + }; + cpus { cpu at 0 { compatible = "mips,mips14kc";
@@ -56,4 +70,82 @@ <0xbf801500 0x200>; /* out */ status = "disabled"; }; + + gpioA: gpio0 at 1f860000 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860000 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioB: gpio1 at 1f860100 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860100 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioC: gpio2 at 1f860200 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860200 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioD: gpio3 at 1f860300 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860300 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioE: gpio4 at 1f860400 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860400 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioF: gpio5 at 1f860500 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860500 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioG: gpio6 at 1f860600 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860600 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioH: gpio7 at 1f860700 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860700 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioJ: gpio8 at 1f860800 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860800 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + gpioK: gpio9 at 1f860900 { + compatible = "microchip,gpio-bank"; + reg = <0xbf860900 0x24>; + gpio-controller; + #gpio-cells = <2>; + }; + + ethernet: ethernet at 1f882000 { + compatible = "microchip,pic32mzda-eth"; + reg = <0xbf882000 0x1000>; + interrupts = <153 IRQ_TYPE_LEVEL_HIGH>; + phy-mode = "rmii"; + status = "disabled"; + }; };
arch/mips/dts/pic32mzda_sk.dts +5 -0
@@ -36,3 +36,8 @@ status = "okay"; u-boot,dm-pre-reloc; }; + +ðernet { + reset-gpios = <&gpioJ 15 0>; + status = "okay"; +};
configs/pic32mzdask_defconfig +9 -0
@@ -7,6 +7,7 @@ CONFIG_SYS_LITTLE_ENDIAN=y CONFIG_HUSH_PARSER=y CONFIG_SYS_HUSH_PARSER=y CONFIG_SYS_PROMPT="dask # " +CONFIG_CMD_NET=y CONFIG_CMD_TIME=y # CONFIG_CMD_IMLS is not set CONFIG_SUPPORT_OF_CONTROL=y
@@ -20,3 +21,11 @@ CONFIG_CLK=y CONFIG_PINCTRL=y # CONFIG_PINCTRL_FULL is not set CONFIG_PIC32_PINCTRL=y +CONFIG_DM_GPIO=y +CONFIG_CMD_GPIO=y +CONFIG_PIC32_GPIO=y +CONFIG_NET=y +CONFIG_DM_ETH=y +CONFIG_PHYLIB=y +CONFIG_NETDEVICES=y +CONFIG_PIC32_ETH=y
include/configs/pic32mzdask.h +22 -0
@@ -100,6 +100,28 @@ (CONFIG_SYS_CBSIZE + sizeof(CONFIG_SYS_PROMPT) + 16)#define CONFIG_CMDLINE_EDITING 1 +/*----------------------------------------------------------------------- +* Networking Configuration +*/ +#define CONFIG_MII +#define CONFIG_PHY_SMSC + +#define CONFIG_CMD_MII +#define CONFIG_CMD_PING +#define CONFIG_CMD_DHCP +#define CONFIG_PHY_ADDR 0/* LAN87XX */ +#define CONFIG_ARP_TIMEOUT 500/* millisec */ +#define CONFIG_NET_RETRY_COUNT 20 +#define CONFIG_SYS_RX_ETH_BUFFER 8 + +/* +* BOOTP options +*/ +#define CONFIG_BOOTP_BOOTFILESIZE +#define CONFIG_BOOTP_BOOTPATH +#define CONFIG_BOOTP_GATEWAY +#define CONFIG_BOOTP_HOSTNAME +/* * Handover flattened device tree (dtb file) to Linux kernel */
Signature · 1 line
1.8.3.1