nftables: DNAT state in connection tracking?
Hi,
in my old iptables setup I've used something like this in the FORWARD chain to allow traffic that has been redirected through DNAT beforehand (i.e. in the NAT PREROUTING table).
iptables -A FORWARD -m conntrack --ctstate DNAT -j ACCEPT
This way I don't have to specify rules twice, which is not only a massive overhead, but also prone to errors. Apparently nftables does not know anything about the "DNAT" and "SNAT" states.
Is there a way to simulate something like this? Marking all packages that are redirected using DNAT in the nat table, and allowing all marked packages through in the forwarding chain, should work, shouldn't it? Is this in any way different to the iptables approach?
Thanks!
Best regards,
Karol Babioch
Quoted 8 lines · Karol Babioch
Hi,
in my old iptables setup I've used something like this in the FORWARD chain to allow traffic that has been redirected through DNAT beforehand (i.e. in the NAT PREROUTING table).
iptables -A FORWARD -m conntrack --ctstate DNAT -j ACCEPT
Quoted 8 lines
This way I don't have to specify rules twice, which is not only a massive overhead, but also prone to errors. Apparently nftables does not know anything about the "DNAT" and "SNAT" states.
Is there a way to simulate something like this? Marking all packages that are redirected using DNAT in the nat table, and allowing all marked packages through in the forwarding chain, should work, shouldn't it? Is this in any way different to the iptables approach?
I think:
nft add rule filter forward ct status dnat accept
should do the trick for you.