QCA99XX, IBSS, and no transmitted frames?
Just curious if anyone has any ideas...I've been staring that this one for days without much luck...
Test case is to bring up two 9990 NICs, using my kernel and firmware, and then run 56kbps UDP traffic bi-directional.
It works for a bit, and then I see a case where one side cannot seem to answer ARP. I still see beacons from it, and probe responses, and I see it receive ARP and try to respond at the netdev level.
But, when sniffing the air, I do not see any ARP response on the air. I've tried verifying the rate-ctrl logic is right and all of that.
Unless I'm really missing something, this is a firmware issue.
Any suggestions for what might be the issue? Anyone else see problems where 9990 NICs go selectively silent on transmit?
Thanks,
Ben
Signature · 8 lines
Ben Greear <[email protected]> Candela Technologies Inc http://www.candelatech.com _______________________________________________ ath10k mailing list [email protected] http://lists.infradead.org/mailman/listinfo/ath10k