equal-cost multipath in 2.6.7
Sending out this question again.
Quoted 11 lines · Darshan Purohit
I have question about multipath routing. I am running a 2.6.7 kernel (gentoo). I have a route with three nexthops on the same interface. I see a different nexthop being picked for different destination addresses. All is fine.
Now if one of the nexthop goes down (arp entry times out and arp request doesnt get a response), does it remove the nexthop from contention and only use the remaining two from this point on ? What about the flows for which this nexthop was chosen in the recent past. Would they move to a different nexthop ?
Quoted 7 lines
Can anyone please point me to implementation details about how a nexthop is chosen and what is the algorithm used in case of multipath routes and how to fine-tune the behaviour.
Thanks.
Darshan.
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
Quoted 21 lines · Darshan Purohit
Sending out this question again.
Quoted 17 lines · Darshan Purohit
I have question about multipath routing. I am running a 2.6.7 kernel (gentoo). I have a route with three nexthops on the same interface. I see a different nexthop being picked for different destination addresses. All is fine.
Now if one of the nexthop goes down (arp entry times out and arp request doesnt get a response), does it remove the nexthop from contention and only use the remaining two from this point on ? What about the flows for which this nexthop was chosen in the recent past. Would they move to a different nexthop ?
Can anyone please point me to implementation details about how a nexthop is chosen and what is the algorithm used in case of multipath routes and how to fine-tune the behaviour.
Thanks.
Darshan.
I suggest you ask Julian Anastasov:
--
gypsy
_______________________________________________
LARTC mailing list
[email protected]
http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc