Skip to contentSkip to conversation

Serial ATA Lockups

DISCUSSION Robert Hancock 1 participant 1 message Dec 28, 2005 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 8 lines · Tomas Carnecky

My setup: Shuttle XPC Barebone, AMD CPU, two serial ATA disks in a software raid setup.
When the system is under heavy load (start World of Warcraft, dd if=/dev/zero of=/part/file etc) I get these messages in dmesg:

ata1: translated ATA stat/err 0x51/84 to SCSI SK/ASC/ASCQ 0xb/47/00
ata1: status=0x51 { DriveReady SeekComplete Error }
ata1: error=0x84 { DriveStatusError BadCRC }

over and over, pages with these messages.

BadCRC indicates CRC errors during data transfers on the SATA interface. This is almost certainly hardware problems - most likely a bad SATA cable, or maybe a bad drive or motherboard controller.

Signature · 3 lines
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from [email protected]
Home Page: http://www.roberthancock.com/