R: Re: Changing endianness of at91sam926x causes u-boot to crash
Quoted 16 lines
----Messaggio originale----
Da: ulf.samuelsson at atmel.com
Data: 15/01/2009 20.47
A: "dibacco at libero.it"<[email protected]>
Cc: <[email protected]>
Ogg: Re: [U-Boot] Changing endianness of at91sam926x causes u-boot to crashtor 2009-01-15 klockan 19:17 +0100 skrev dibacco at libero.it:
Quoted 6 lines
Hi all,
I have a board with at91sam9260 configured as little endian (via strap pin). The u-boot is working quite well.
On the board there is a chip whose
driver was written for PowerPC that is big endian. Unfortunately the
driver was
Quoted 2 lines
Quoted 2 lines
written in a bad way and it is difficult to fix endiannes dependencies.
I
Quoted 3 lines
Quoted 3 lines
thought to change the endianness of the processor
to big endian. I recompiled
everything with a big endian compiler but the u-boot is crashing. Should
I
Quoted 11 lines
Quoted 2 lines
change something
on my hardware?The AT91 series is strictly small endian.
Before there is an argument, I'd like to point
out people came to the conclusion that
"the only good endian is a dead endian"
years ago.
But my processor has a pin I can configure to change the endianness. Why are you saying it cannot support big endian?