Skip to contentSkip to conversation

TCP=828mbps, UDP=1mbps? (both running 2.6.13.2)

DISCUSSION Daniel J Blueman 1 participant 1 message Sep 28, 2005

lore
Share & tools
lore
#0 lore raw

Justin,

When running iperf in UDP mode (-u), you must specify a bandwidth, ie:

server$ iperf -s -u
client$ iperf -c server -u -b 1000M

Quoted 39 lines · Justin Piszcz

Any idea why with TCP I get 828 megabits on my gigabit connection but only 1.05 megabits with UDP?

Using iperf to benchmark.

TCP
------------------------------------------------------------
Server listening on TCP port 5001
TCP window size: 85.3 KByte (default)
------------------------------------------------------------
[ 4] local 192.168.1.12 port 5001 connected with 192.168.1.253 port 48853
[ 4] 0.0-35.1 sec 3.38 GBytes 828 Mbits/sec

UDP
------------------------------------------------------------
Server listening on UDP port 5001
Receiving 1470 byte datagrams
UDP buffer size: 101 KByte (default)
------------------------------------------------------------
[ 3] local 192.168.1.12 port 5001 connected with 192.168.1.253 port 32773
[ 3] 0.0-10.0 sec 1.25 MBytes 1.05 Mbits/sec 0.043 ms 0/ 893 (0%)

p34:~$ netstat -i
Kernel Interface table
Iface   MTU Met   RX-OK RX-ERR RX-DRP RX-OVR    TX-OK TX-ERR TX-DRP TX-OVR
Flg
eth0   1500 0   1266337      0      0      0  2588651      0      0      0
BMRU
eth1   1500 0      2358      0      0      0     2229      0      0      0
BMRU
eth2   1500 0     39706      0      0      0     5747      0      0      0
BMNRU
lo    16436 0       184      0      0      0      184      0      0      0
LRU
Quoted 8 lines
box2:~$ netstat -i
Kernel Interface table
Iface   MTU Met   RX-OK RX-ERR RX-DRP RX-OVR    TX-OK TX-ERR TX-DRP TX-OVR
Flg
eth0   1500 0   2955176      0      0      0  3696501      0      0      0
BMRU
lo    16436 0       612      0      0      0      612      0      0      0
LRU

___
Daniel J Blueman