Skip to contentSkip to conversation

LVM disk power management

linux-lvm Drew... 2 participants 2 messages Feb 8, 2015 – Feb 9, 2015

lore
Share & tools
lore

Drew...

author
#0 lore raw

Hi,
I have 3 physical disks forming one volume group, with one logical volume. If i try to issue a standby command to the logical volume i get the following error.. sudo hdparm -y /dev/mapper/VG0-LVstorage

/dev/mapper/VG0-LVstorage:

issuing standby command

HDIO_DRIVE_CMD(standby) failed: Inappropriate ioctl for device

But if i issue a standby command to the individual disks in the volume group.. sudo hdparm -y /dev/sda1 /dev/sdb1 /dev/sdc1

/dev/sda1:

issuing standby command

/dev/sdb1:

issuing standby command

/dev/sdc1:

issuing standby command
This works fine!
Is addressing individual disks the normal way to to spin down disks in a lvm volume group or will this cause file corruption.
And if not, is there a safe way to achieve this or is it just not possible to spin down disks in a lvm.
I would be grateful of any advice you could offer. I have spent some time searching around for some information on this & i can not find any documented on this anywhere. Thanks,
Kind regards,
Drew

#1 lore raw

Dne 8.2.2015 v 19:59 Drew... napsal(a):

Quoted 30 lines

Hi,
I have 3 physical disks forming one volume group, with one logical volume. If i try to issue a standby command to the logical volume i get the following error..

|sudo hdparm -y /dev/mapper/VG0-LVstorage

/dev/mapper/VG0-LVstorage:

issuing standby command

HDIO_DRIVE_CMD(standby) failed: Inappropriate ioctl for device|

But if i issue a standby command to the individual disks in the volume group..

|sudo hdparm -y /dev/sda1 /dev/sdb1 /dev/sdc1

/dev/sda1:

issuing standby command

/dev/sdb1:

issuing standby command

/dev/sdc1:

issuing standby command|

Quoted 9 lines

This works fine!
Is addressing individual disks the normal way to to spin down disks in a lvm volume group or will this cause file corruption.
And if not, is there a safe way to achieve this or is it just not possible to spin down disks in a lvm.
I would be grateful of any advice you could offer. I have spent some time searching around for some information on this & i can not find any documented on this anywhere.
Thanks,

Yes - you need to 'hdparm' control 'real' devices/PVs. There is no point to try to control logical volumes. Imagine you could have 1000LVs on a single PV.

Regards

Zdenek