software watchdog
Hi all,
I am using software watchdog in my application. When the watchdog reboots the system,
Quoted 1 line
Quoted 1 line
Quoted 1 line
printk(KERN_CRIT "SOFTDOG: Initiating system reboot.\n"); prints the message
on the console.
I put a delay of 5secs with mdelay, and I can see the message on the console. I wanted the message as a syslog,
so I added kern.crit in /etc/syslog.conf file.,
But I am not getting the above message in the log file. Can any one help me with this ????
Thanks
Girish
Quoted 6 lines · [email protected] wrote:
Hi all,
I am using software watchdog in my application. When the watchdog reboots the system,
Quoted 1 line
Quoted 1 line
Quoted 1 line
printk(KERN_CRIT "SOFTDOG: Initiating system reboot.\n"); prints the message
Quoted 8 lines
on the console.
I put a delay of 5secs with mdelay, and I can see the message on the console. I wanted the message as a syslog,
so I added kern.crit in
/etc/syslog.conffile.,
But I am not getting the above message in the log file. Can any one help me with this ????
Send the message to "*" instead of /var/log/messages
That, and/or arrange to do a sync before reboot.
I'm sure there are other ways as well...
cu
jjs
Quoted 5 lines · On Tue, Dec 11, 2001 at 01:33:04PM +0530, [email protected] wrote:
Quoted 1 line
Quoted 1 line
Quoted 1 line
printk(KERN_CRIT "SOFTDOG: Initiating system reboot.\n"); prints themessage on the console.
I put a delay of 5secs with mdelay, and I can see the message on the console. I wanted the message as a syslog,
In order to log this message to syslog, you need to allow the syslog process to run. If you're using a uniprocessor machine, using mdelay() doesn't allow syslog to run during this time.
Softdog has a "testing" mode, which can be enabled by defining ONLY_TESTING. This disables the automatic reboot, but the system will log the timeout message.
--
Russell King ([email protected]) The developer of ARM Linux
http://www.arm.linux.org.uk/personal/aboutme.html