Skip to contentSkip to conversation

software watchdog: it works

DISCUSSION [email protected] 1 participant 1 message Dec 11, 2001

lore
Share & tools
lore
#0 lore raw

Hi,
Thanks a lot for your help. I modified the softdog code and I get the message logged in my log file on system reboot.

Thanks
Girish

Russell King <[email protected]> on 12/11/2001 05:20:59 PM

To: Girish S Pujar/HSS@HSS
cc: [email protected], Atul Chowdhry/HSS@HSS

Subject: Re: software watchdog

Quoted 5 lines · On Tue, Dec 11, 2001 at 04:26:07PM +0530, [email protected] wrote:

Why is that the printk output not going to syslog although I have entry in /etc/syslog.conf

kern.crit /var/log/pbsc.log
even after I remove the mdelay call.

The machine reboots before syslog gets to run.

What happens is:

     printk();
     reboot();

During that period, syslog is unable to run, and therefore is unable to write the log message to disk.

Quoted 2 lines

Does it mean that without using "testing" mode ( I cannot beacuse I need a reboot) it is not possible to get log ?

I suppose you could modify softdog to delay the reboot using it's timer (the timer fires the first time, you check data to see if it's non-zero. If it's not, increment watchdog_ticktock.data, and set the watchdog to timeout in 5 seconds, return).

You should probably prevent softdog_write updating the timer if the data field is non-zero, so once you don't change the behaviour; this is of course dependent on your test case.

--
Russell King ([email protected]) The developer of ARM Linux
http://www.arm.linux.org.uk/personal/aboutme.html