Skip to contentSkip to conversation

x86_64 invalid opcode

DISCUSSION Robert Hancock 1 participant 1 message May 4, 2006 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 3 lines · chris perkins

hi - i'm running the 2.6.16.13 x86_64 kernel on an athlon 64 and periodically get invalid opcode and general protection faults. the system continues to run for about 10 minutes following this and then crashes. i've had similar problems with previous 2.6 kernels but unfortunately don't have a capture of the output. below is the syslog output and my .config... has anyone else seen anything similar? thanks,
chris perkins

This could be caused by problems with your RAM, have you tried running memtest86?

Signature · 3 lines
Robert Hancock      Saskatoon, SK, Canada
To email, remove "nospam" from [email protected]
Home Page: http://www.roberthancock.com/