U-Boot 1.1.3 does not boot with MPC8349E
I didn't change the flash address but rather the text segment start address from 0xFE700000 to 0xFE000000 in board/mpc8349ads/config.mk (see also my message from 2005-10-11 08:25).
I used the commands as described in the README:
tftp 10000 u-boot.bin
protect off fe000000 fe09ffff
erase fe000000 fe09ffff
cp.b 10000 fe000000 a0000
Servus,
Florian.
Matthew McClintock <[email protected]> schrieb am 19.10.2005 09:00:50:
Quoted 16 lines
Did you find a solution to your problem? Neil Chu just sent a patch in today that corrects values in the MPC8349 readme. Can you give a listing of the commands you used to program the new u-boot onto your board?
-Matthew
Quoted 1 line · On Mon, 2005-10-10 at 18:15 +0200, flobe01 at arcor.de wrote:
Has anybody tried to bring up U-Boot 1.1.3 together with a (Power
Quicc II Pro) MPC8349E MDS Processor Board (silicon rev 1.0)? The board comes with a (probably patched) 1.1.2 version installed. I want to update it to 1.1.3 in order to be able to use a current Linux kernel (2.6.13 - U-Boot 1.1.2 seems to be incompatible due to differences in the
bd_infostructures, right?).Quoted 2 lines
After building U-Boot and writing to the flash according to the
Quoted 11 lines
README, the board does show no more signs of life (apart from the reset sequence leds) after hard reset.
Quoted 2 lines
I used crosstool 0.38 for building the tool chain with a standard
ppc target (-mcpu=powerpc) and gcc 3.4.1.
Quoted 2 lines
Are there any board settings necessary other than those defaults
in the Getting Started guide?
Quoted 3 lines
Thanks and regards,
Florian.
Machen Sie aus 14 Cent spielend bis zu 100 Euro!
Die neue Gaming-Area von Arcor - ?ber 50 Onlinespiele im Angebot.
http://www.arcor.de/rd/emf-gaming-1