MPC8541CDS board PHY interface
Hi,
We have designed a MPC8541 based card taking MPC8541CDS card as reference . In our card we have provided marvell Gigabit Dual PHY chip "MV88E1121" on the Tsec RGMII interface. We are using U-Boot as firmware . We have changed the value of first two elements of structure "phy_info " from 0x01410c6 & "Marvell 88E1011S" to 0x01410cb & "Marvell 88E1121S"respectively in in tsec.c file. These changes we have made as per the PHY identifier 1 & PHY identifier 2 from the 88E1121 datasheet . With these changes U-boot is able to recognize our Phy chip .
As per MPC8555ERM.pdf document TX_CLK for the PHY will be supplied by the powerPC in RGMII mode . In our case we are not getting this clock. We are not able to ping our board.
we want to know what all changes are required in the U-Boot code to initialize the PowerPC for RGMII operation.
Thanks & regards
M Ravi
Download prohibited? No problem. CHAT from any browser, without download. Go to http://in.messenger.yahoo.com/webmessengerpromo.php/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.denx.de/pipermail/u-boot/attachments/20080226/8de6b71a/attachment.htm
Quoted 1 line · M Ravi Prakash Reddy
Hi,
Hi Ravi,
[snip]
Quoted 3 lines
As per MPC8555ERM.pdf document
TX_CLKfor the PHY will be supplied by
the powerPC in RGMII mode . In our case we are not getting this clock. We are not able to ping our board.
Be aware that u-boot has a "ping" command that you can use to ping *other* computers. U-boot does *NOT* respond to a ping from another computer (short explanation: u-boot is a simple polled mode program).
Quoted 2 lines
we want to know what all changes are required in the U-Boot code to
initialize the PowerPC for RGMII operation.
Answered by Manish Jaggi (I'm not qualified to answer this).
Quoted 2 lines
Thanks & regards
M Ravi
HTH,
gvb