serial/8250: Platform override of is_real_interrupt
Hi,
I'm using the serial/8250 driver on a ML300 based PPC board which uses interrupt vector 0 for the UART.
is_real_interrupt() unfortunately interpretes IRQ0 as meaning no interrupt, so performance is kinda crap.
How to fix? 8250.c is setup so that asm/serial.h is included after the definition of is_real_interrupt and the idea is that you can redefine it in your platform header if needed. Now, this doesn't work on PPC as the platform headers are included in asm/io.h AND asm/serial.h so they won't be reparsed the second time.
I see 3 options:
1) Put an #ifndef is_real_interrupt around the is_real_interrupt definition so the platform header can define it's own version independent of inclusion order.
2) A lot of platforms (but not all) define NO_IRQ to something sensible (-1). Define is_real_interrupt in terms of NO_IRQ instead of testing against 0. For the remaining platforms we could locally define NO_IRQ to 0 to keep the old behavior.
3) Put the redefine directly in asm/serial.h surrounded by an #ifdef CONFIG_XILINX_ML300 (ugly)
Which solution is preferable?
Signature · 1 line
Bye, Peter Korsgaard
Quoted 2 lines · Peter Korsgaard
is_real_interrupt()unfortunately interpretes IRQ0 as meaning no interrupt, so performance is kinda crap.
This was discussed some time ago and the answer is "none of the below"
http://lkml.org/lkml/2005/11/21/211
Your hardware platform should be mapping interrupts so that the cookie dev->irq is not 0 for a valid IRQ.
Alan
Quoted 2 lines · Alan Cox
Your hardware platform should be mapping interrupts so that the cookie
dev->irqis not 0 for a valid IRQ.
Thanks. I'll do that instead then.
--
Bye, Peter Korsgaard