Skip to contentSkip to conversation

Adaptec AHA-2940U2W "Data Parity Error Dectected" messages

DISCUSSION Daniel Pittman 2 participants 3 messages Aug 9, 2005

lore
Share & tools
lore
#0 lore raw

I recently installed a SCSI tape drive and Adaptec AHA-2940U2W SCSI controller into my server to run backups.

Since then, the driver issues these warnings on a semi-regular basis while the drive is busy:

Aug  9 17:00:26 anu kernel: scsi0: Data Parity Error Detected during address or write data phase
Aug  9 17:00:26 anu kernel: scsi0: PCI error Interrupt at seqaddr = 0x8

[...]

Aug  9 17:03:34 anu kernel: scsi0: Data Parity Error Detected during address or write data phase

[...]

Aug  9 17:04:36 anu kernel: scsi0: PCI parity error checking has been disabled.
Aug  9 17:04:36 anu kernel: scsi0: Some device on this bus is generating bad parity.
Aug  9 17:04:36 anu kernel: scsi0: This is an error *observed by*, not *generated by*, this controller.
Aug  9 17:04:36 anu kernel: scsi0: Too many PCI parity errors observed as a target.
Aug  9 17:04:36 anu kernel: scsi0: WARNING WARNING WARNING WARNING

Now, the log message claims that the SCSI controller is not responsible for these parity errors, so my questions are:

* should I panic about this?
* should I have seen this before the SCSI controller was installed?
* can I do anything about it, or identifying the cause?

Thanks,
Daniel

#1 lore raw
Quoted 8 lines · Daniel Pittman

I recently installed a SCSI tape drive and Adaptec AHA-2940U2W SCSI controller into my server to run backups.

Since then, the driver issues these warnings on a semi-regular basis while the drive is busy:

Aug  9 17:00:26 anu kernel: scsi0: Data Parity Error Detected during address or write data phase
Aug  9 17:00:26 anu kernel: scsi0: PCI error Interrupt at seqaddr = 0x8

Make sure the hardware is all installed correctly. Check that the card is fully seated, or try it in another PCI slot. Also check your cabling and termination.

Lee

#2 lore raw
Quoted 4 lines · Lee Revell
Quoted 3 lines · Daniel Pittman

I recently installed a SCSI tape drive and Adaptec AHA-2940U2W SCSI controller into my server to run backups.

Quoted 8 lines
Quoted 5 lines

Since then, the driver issues these warnings on a semi-regular basis while the drive is busy:

Aug  9 17:00:26 anu kernel: scsi0: Data Parity Error Detected during address or write data phase
Aug  9 17:00:26 anu kernel: scsi0: PCI error Interrupt at seqaddr = 0x8

Make sure the hardware is all installed correctly. Check that the card is fully seated, or try it in another PCI slot.

Thanks. I will take the server down shortly and give that a shot.

Quoted 1 line

Also check your cabling and termination.

Could SCSI cabling and/or termination cause the card to report *PCI* errors, or am I misunderstanding these messages?

I guess that the fact that the "PCI" bit kept showing up in them is what confuses me. I didn't except a SCSI card to report PCI bus issues through the Linux driver, and since it claimed to be a victim, not a cause, I didn't know quite how to trace the problem down...

Thanks,
Daniel