Skip to contentSkip to conversation

ir-kbd-i2c - Universal Remote does not work anymore.

DISCUSSION A. P. Kennedy 1 participant 1 message Mar 10, 2009 Media (V4L/DVB)

lore
Share & tools
lore
#0 lore raw

Hello,

Summary of problem.

I have been using the ir-kbd-i2c module for several years with an one-for-all universal remote. I have a pvr-350 and the original gray hauppauge remote was broken. There was a change in the code in the ir-kbd-i2c module that started filtering remote device ids and only a hauppauge remote can work with the pvr-350 (or any other hauppauge version).

Start of long version.

I decided to upgrade my kernel and the remote stopped working. After some searching on the net, I found out why the one-for-all universal remote has stopped working. The following code was added to the ir-kbd-i2c module.

    /*
     * Hauppauge remotes (black/silver) always use
     * specific device ids. If we do not filter the
     * device ids then messages destined for devices
     * such as TVs (id=0) will get through causing
     * mis-fired events.
     *
     * We also filter out invalid key presses which
     * produce annoying debug log entries.
     */
    ircode= (start << 12) | (toggle << 11) | (dev << 6) | code;
    if ((ircode & 0x1fff)==0x1fff)
        /* invalid key press */
        return 0;

    if (dev!=0x1e && dev!=0x1f)
        /* not a hauppauge remote */
        return 0;

By removing the last three lines the one-for-all universal remote now works just fine, or changing the device id in the above code to the universal remote everything works fine.

I have never had the problem that the code is supposed to fix. I have never had a misfired event discussed above. I have a key programmed for the universal remote for the hauppauge and this solution has worked great for the last several years. The device id for the one-for-all remote is 5 and the device id cannot be changed on the remote.

I am requesting that an option be added to send the module another device id or to turn the device id filtering off. I am not a programmer or developer so I do not know which way would be best to proceed.

Any help with this problem would be greatly appreciated.

Thanks,

Alan

--
video4linux-list mailing list
Unsubscribe mailto:[email protected]?subject=unsubscribe
https://www.redhat.com/mailman/listinfo/video4linux-list