Skip to contentSkip to conversation

Adaptec ARO-1130CA-C

DISCUSSION Turbo Fredriksson 2 participants 3 messages Feb 14, 2004 – Feb 15, 2004 1 message not in the archive

lore
Share & tools
lore
#0 lore raw

I have a motherboard (Intel DK440LX) with a built in SCSI controller (AIC-7895). To this MB there's the possibility to have a RAIDport II controller. I managed to get me a 'Adaptec ARO-1130CA-C' from eBay because I couldn't in my wildest dreams believe that Linux didn't support it - it's ancient!.

Woe my surprise when I discovered that it isn't! The latest information
I have about this - which is "no, it isn't supported" - come from 2002
or thereabouts. I have not been able to find ANYTHING later than 2002,
other than a note from Alan Cox (http://marc.theaimsgroup.com/?l=linux-kernel&m=92185700225899&w=2)
stating that _maybe_ the new AACRAID _might_ support this. Looking at
the AIC7xxx documentation (in 2.4.24), I see the following, so clearly
it isn't supported by the aic7xxx driver, but my hopes are that AACRAID
DOES support it.

drivers/scsi/README.aic7xxx:
----- s n i p -----
Not Supported Devices
------------------------------
Adaptec Cards
----------------------------
AHA-2920 (Only the cards that use the Future Domain chip-set are not
supported, any 2920 cards based on Adaptec AIC chip-sets, such as the 2920C, are supported)
AAA-13x Raid Adapters
AAA-113x Raid Port Card

Motherboard Chipsets
----------------------------
AIC-781x

Bus Types
----------------------------
R - Raid Port busses are not supported.

The hardware RAID devices sold by Adaptec are *NOT* supported by this driver (and will people please stop emailing me about them, they are a totally separate beast from the bare SCSI controllers and this driver can not be retrofitted in any sane manner to support the hardware RAID features on those cards - Doug Ledford).
----- s n i p -----

It is NOT a 'AAA-113x', but I guess it's the same card with a different vendor. So the question is: IS it (my RAIDport II card) supported by the aacraid driver, in either 2.4 _or_ (if need be) the 2.6 kernels?

#1 lore raw
Quoted 8 lines · Turbo Fredriksson

I have a motherboard (Intel DK440LX) with a built in SCSI controller (AIC-7895). To this MB there's the possibility to have a RAIDport II controller. I managed to get me a 'Adaptec ARO-1130CA-C' from eBay because I couldn't in my wildest dreams believe that Linux didn't support it - it's ancient!.
It is NOT a 'AAA-113x', but I guess it's the same card with a different vendor. So the question is: IS it (my RAIDport II card) supported by the aacraid driver, in either 2.4 _or_ (if need be) the 2.6 kernels?

To the best of my knowledge, no, aacraid does not support any of the RAIDport cards.

Signature · 4 lines
Matt Domsch
Sr. Software Engineer, Lead Engineer
Dell Linux Solutions linux.dell.com & www.dell.com/linux
Linux on Dell mailing lists @ http://lists.us.dell.com

A message that is not in the archive (sent off-list or not yet received): [email protected]

#3 lore raw

Quoting Scott Long <[email protected]>:

Quoted 5 lines · Matt Domsch
Quoted 4 lines · Turbo Fredriksson
Quoted 2 lines

So the question is: IS it (my RAIDport II card) supported by the aacraid driver, in either 2.4 _or_ (if need be) the 2.6 kernels?

Quoted 7 lines
Quoted 3 lines

To the best of my knowledge, no, aacraid does not support any of the RAIDport cards.

That is correct, the AAA and ARO products are not supported by the aacraid nor dpti20 drivers, nor any other linux driver, open source or otherwise.

Is there a reason why not? Other than 'non-one have the time' etc that is... I would _REALLY APRECIATE_ if someone took the time to write one...

I'm most liklely NOT up to it, I'm not that good a programmer (never done any serious kernel hacking since 1.3 or thereabouts).

If someone cared, I could even lend the mb/raid card to whomever wanted/had the time to do it...