Skip to contentSkip to conversation

Please add PCI id

PATCH Yoshinori Sato 2 participants 2 messages Apr 13, 2012 Atheros ATH5K wireless driver

lore
Share & tools
lore
#0 lore raw

This device works fine of ath5k.

Details bellow
05:00.0 0200: 168c:ff1b (rev 01)
05:00.0 Ethernet controller: Atheros Communications Inc. Device ff1b (rev 01)
Flags: bus master, fast devsel, latency 0, IRQ 19
Memory at febf0000 (64-bit, non-prefetchable) [size=64K]
Capabilities: <access denied>
Kernel driver in use: ath5k

ath5k 0000:05:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 ath5k 0000:05:00.0: setting latency timer to 64 ath5k 0000:05:00.0: registered as 'phy0'
ath: EEPROM regdomain: 0x67
ath: EEPROM indicates we should expect a direct regpair map
ath: Country alpha2 being used: 00
ath: Regpair used: 0x67
ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' ath5k phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70)

drivers/net/wireless/ath/ath5k/pci.c +1 -0
index eaf79b4..1be418c 100644
@@ -44,6 +44,7 @@ static DEFINE_PCI_DEVICE_TABLE(ath5k_pci_id_table) = {
 	{ PCI_VDEVICE(ATHEROS, 0x001b) }, /* 5413 Eagle */
 	{ PCI_VDEVICE(ATHEROS, 0x001c) }, /* PCI-E cards */
 	{ PCI_VDEVICE(ATHEROS, 0x001d) }, /* 2417 Nala */
+	{ PCI_VDEVICE(ATHEROS, 0xff1b) }, /* AR5BXB63 */
 	{ 0 }
 };
 MODULE_DEVICE_TABLE(pci, ath5k_pci_id_table);
Signature · 2 lines
Yoshinori Sato
<[email protected]>
#1 lore raw

Hi,

0xff1b indicates the device wasn't correctly setup post power on.

So I'd try to find out exactly why that is.

Adrian

Quoted 42 lines · Yoshinori Sato

This device works fine of ath5k.

Details bellow
05:00.0 0200: 168c:ff1b (rev 01)
05:00.0 Ethernet controller: Atheros Communications Inc. Device ff1b (rev 01)
       Flags: bus master, fast devsel, latency 0, IRQ 19
       Memory at febf0000 (64-bit, non-prefetchable) [size=64K]
       Capabilities: <access denied>
       Kernel driver in use: ath5k

ath5k 0000:05:00.0: PCI INT A -> GSI 19 (level, low) -> IRQ 19 ath5k 0000:05:00.0: setting latency timer to 64 ath5k 0000:05:00.0: registered as 'phy0'
ath: EEPROM regdomain: 0x67
ath: EEPROM indicates we should expect a direct regpair map
ath: Country alpha2 being used: 00
ath: Regpair used: 0x67
ieee80211 phy0: Selected rate control algorithm 'minstrel_ht' ath5k phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70)

drivers/net/wireless/ath/ath5k/pci.c +0 -0
index eaf79b4..1be418c 100644
@@ -44,6 +44,7 @@ static DEFINE_PCI_DEVICE_TABLE(ath5k_pci_id_table) = {

       { PCI_VDEVICE(ATHEROS, 0x001b) }, /* 5413 Eagle */ { PCI_VDEVICE(ATHEROS, 0x001c) }, /* PCI-E cards */ { PCI_VDEVICE(ATHEROS, 0x001d) }, /* 2417 Nala */
+       { PCI_VDEVICE(ATHEROS, 0xff1b) }, /* AR5BXB63 */ { 0 }
 };
 MODULE_DEVICE_TABLE(pci, ath5k_pci_id_table);

--
Yoshinori Sato
<[email protected]>
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html