drm: refresh rate down to 60 Hz in 2.6.35-rc5
Subsystems (2)
After upgrading to 2.6.35-rc5, I noticed that my monitor reports a refresh rate of 60 Hz when nouveau.ko is loaded, rather than the 75 Hz I got on 2.6.34. Graphics card is an NV86 (GeForce 8500 GT), the monitor is a 1280x1024 TFT (Yakumo 19AL) connected via VGA.
I bisected this to the following commit:
--8<---------------cut here---------------start------------->8--- commit c867df7043b738da4f4d358d7039c243a29b4272
Author: Adam Jackson <[email protected]> Date: Mon Mar 29 21:43:21 2010 +0000
drm/edid: Reshuffle mode list construction to closer match the spec
Also, document what the spec says to do.
Signed-off-by Adam Jackson <[email protected]>
Signed-off-by Dave Airlie <[email protected]>
drivers/gpu/drm/drm_edid.c +16 -2
@@ -1377,10 +1377,24 @@ int drm_add_edid_modes(struct drm_connector *connector, struct edid *edid) quirks =edid_get_quirks (edid); - num_modes +=add_established_modes (connector, edid); - num_modes +=add_standard_modes (connector, edid); +/* +* EDID spec says modes should be preferred in this order: +* - preferred detailed mode +* - other detailed modes from base block +* - detailed modes from extension blocks +* - CVT 3-byte code modes +* - standard timing codes +* - established timing codes +* - modes inferred from GTF or CVT range information +* +* We don't quite implement this yet, but we're close. +* +* XXX order for additional mode types in extension blocks? +*/ num_modes +=add_detailed_info (connector, edid, quirks); num_modes +=add_detailed_info_eedid (connector, edid, quirks); + num_modes +=add_standard_modes (connector, edid); + num_modes +=add_established_modes (connector, edid);if (quirks & (EDID_QUIRK_PREFER_LARGE_60 |EDID_QUIRK_PREFER_LARGE_75 ))edid_fixup_preferred (connector, quirks);
--8<---------------cut here---------------end--------------->8---
How do I get the 75 Hz refresh rate back? Adding "video=1280x1024@75" as described in the nouveau wiki¹ has no effect.
Regards,
Sven