enabling d-cache in OSK 5912 OSK
Hi,
I am using OMAP 5912 OSK.
I am implementing a command which has lots writes to and reads from memory.
I want to enable the D cache in u-boot.
how do i do it in u-boot.
please advice.
regards,
sriram
Hi,
Quoted 6 lines
I am implementing a command which has lots writes to and reads from memory.
I want to enable the D cache in u-boot.
how do i do it in u-boot.
how about issuing mcr inst in board/omap5912osk/lowlevel_init.S ?
Best Regards,
HK.
--
Quoted 2 lines · In message <[email protected]> you wrote:
Quoted 2 lines
I want to enable the D cache in u-boot.
Use dcache_enable(). Implement it if needed.
Quoted 1 line
how about issuing mcr inst in
board/omap5912osk/lowlevel_init.S?
No. There is a standard way to do this (using ?cache_enable()), and this should be used here, too.
Best regards,
Wolfgang Denk
Signature · 3 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de When all is said and done, more is said than done.